首页> 外文期刊>International Journal of Applied Ceramic Technology / Functional Ceramics >Crystallization of Ferroelectric Lead Zirconate Titanate Thin Films by Microwave Annealing at Low Temperatures
【24h】

Crystallization of Ferroelectric Lead Zirconate Titanate Thin Films by Microwave Annealing at Low Temperatures

机译:低温微波退火对铁电锆钛酸铅钛薄膜的晶化

获取原文
获取原文并翻译 | 示例
           

摘要

Lead zirconate titanate (PZT) thin films were coated on Pt/Ti/ SiO_2/Si substrates by the sol-gel method and then crystallized by microwave annealing using a single-mode 2.45 GHz microwave irradiation system in the magnetic field. The crystalline phases and microstructures as well as the ferroelectric properties of the PZT films were investigated as a function of the elevated temperature generated by microwave irradiation, and the phase transition in the crystallization of the PZT thin films was discussed. X-ray diffraction analysis and transmission electron microscopic study indicated that the crystallization to the per-ovskite phase in the PZT films by microwave annealing started at 430℃, and mostly finished at 450℃ for 30 min. The reman-ent polarization of the PZT films increased with the increasing annealing temperature, and the lowest temperature required to obtain perovskite PZT films with good ferroelectric properties in the microwave irradiation processing was 450℃, which is much lower than that in conventional thermal processing.
机译:通过溶胶-凝胶法将锆酸钛酸铅(PZT)薄膜涂覆在Pt / Ti / SiO_2 / Si衬底上,然后在磁场中使用单模2.45 GHz微波辐射系统通过微波退火使其结晶。研究了PZT薄膜的晶相和微结构以及铁电性能与微波辐射产生的高温的关系,并讨论了PZT薄膜结晶过程中的相变。 X射线衍射分析和透射电镜研究表明,微波退火使PZT薄膜结晶为钙钛矿相,始于430℃,大部分在450℃完成30min。随着退火温度的升高,PZT膜的剩余极化强度增加,在微波辐照过程中获得具有良好铁电性能的钙钛矿PZT膜所需的最低温度为450℃,远低于常规热处理的温度。

著录项

  • 来源
  • 作者单位

    Shenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences,Shenyang 110016, China;

    rnShenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences,Shenyang 110016, China;

    rnDepartment of Materials Science and Engineering, Graduate School of Engineering, Tohoku University, Sendai 980-8579, Japan;

    rnShenyang National Laboratory for Materials Science, Institute of Metal Research, Chinese Academy of Sciences,Shenyang 110016, China;

    rnDepartment of Materials Science and Engineering, Graduate School of Engineering, Tohoku University, Sendai 980-8579, Japan;

    rnDepartment of Materials Science and Engineering, Graduate School of Engineering, Tohoku University, Sendai 980-8579, Japan;

  • 收录信息 美国《科学引文索引》(SCI);美国《工程索引》(EI);美国《生物学医学文摘》(MEDLINE);
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号