...
首页> 外文期刊>Chemical Product and Process Modeling >Optimization of the Ratio of ω-6 Linoleic and ω-3 α-Linolenic Fatty Acids of Hemp Seed Oil with Jackknife and Bootstrap Resampling
【24h】

Optimization of the Ratio of ω-6 Linoleic and ω-3 α-Linolenic Fatty Acids of Hemp Seed Oil with Jackknife and Bootstrap Resampling

机译:优化Jimp种子油与千刀和卷放重采样的ω-6亚油和ω-3α-亚麻酸脂肪酸的比率

获取原文
获取原文并翻译 | 示例
           

摘要

In the present work,supercritical fluid extraction(SFE)of hemp(Cannabis sativa)seed oil at various ranges of SFE parameters is performed.These parameters and respective ranges are temperature(40–80)°C,pressure(200–350)bar,solvent(CO2)flow rate(5–15)g/min,particle size(0.43–1.02)mm and amount of co-solvent(ethanol)(0–10)% of solvent flow rate.Central composite design(CCD)suggests 32 experimental runs to perform through SFE.The obtained oil is analysed through gas chromatography to identify its fatty acids concentrations.The ratio of ω-6 linoleic and ω-3 α-linolenic fatty acids(ω-6/ω-3)is optimized through CCD to obtain the desired amount of 3:1 as this ratio is highly preferred for various health benefits.Ratio of ω-6/ω-3 is obtained in the range from 2.11 to 3.06:1 for all experimental runs.The effect of SFE parameters on this ratio is investigated.Further,cross-validation is peformed on the experimental data obtained for the concentrations of both fatty acids by jackknife and bootstrap resampling to authenticate the obtained data.Small value of standard deviation(~1),less standard error of the mean(SEM)(<0.8)and less variance coefficient(<0.11)confirms the validity of the obtained data.All the estimators'values such as standard deviation,variance coefficients and SEM are observed in 95 % of confidence intervals.
机译:在本作工作中,进行了大麻(Cannabis Sativa)种子油的超临界流体萃取(SFE)进行了各种范围的SFE参数。这些参数和各个范围是温度(40-80)°C,压力(200-350)杆,溶剂(CO 2)流速(5-15)G / min,粒度(0.43-1.02)mm和溶剂流量的共溶剂(0-10)%的溶剂流量。中央复合设计(CCD)建议通过SFE进行32种实验运行。通过气相色谱分析得到的油,以鉴定其脂肪酸浓度。ω-6亚油和ω-3α-亚麻酸脂肪酸(ω-6 /ω-3)的比率是通过CCD优化以获得所需量的3:1,因为该比率对于各种健康益处是高度优选的。ω-6 /ω-3的效果为2.11至3.06:1。效果研究了对该比率的SFE参数。核,交叉验证是在由千刀和训练器的脂肪酸浓度获得的实验数据上表现p重采样来验证所获得的数据。标准偏差的标准值(〜1),较少的平均值(SEM)(<0.8)和更小的方差系数(<0.11)确认所获得的数据的有效性。所有估计器“标准偏差,方差系数和SEM等值以95%的置信区间观察到。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号