Oxidative degradation of atenolol by heat-activated persulfate: Kinetics, degradation pathways and distribution of transformation intermediates

摘要

Atenolol (ATL) has been widely detected in wastewater and aquatic environment. Although satisfactory removal of ATL from wastewater could be achieved, the mineralization ratio is usually low, which may result in the accumulation of its transformation products in the effluent and cause additional ecological risk to the environment. The aim of this study is to explore the effectiveness of heat activated persulfate (PS) in the removal of ATL from wastewater. Influencing factors including temperature, PS dosage, solution pH, existence of NO3-,Cl-,HCO(3)( )(-)and Suwannee river fulvic acid (SRFA) were examined. Complete removal of ATL was achieved within 40 min at pH 7.0 and 70 degrees C by using 0.5 mM PS. Inhibitive effects of HCO3- and FA had been observed on ATL oxidation, which was increased with the increase of their concentration. Sulfate radical (SO4-center dot) was determined as the main reactive species by quenching experiment. Eight intermediates produced in ATL degradation were identified, and four degradation pathways were proposed based on the analysis of mass spectrum and frontier electron densities. The distribution of major intermediates was influenced by reaction temperature. Hydroxylation intermediates and deamidation intermediate were the most prominent at 50 degrees C and 60 degrees C, respectively. All intermediates were completely degraded in 40 min except P134 at 70 degrees C. Effective removal of TOC (74.12%) was achieved with 0.5 mM PS, pH 7.0 and 70 degrees C after 240 min. The results proved that heat activation of PS is a promising method to remove organic pollutants in wastewater. (C) 2018 Elsevier Ltd. All rights reserved.