...
首页> 外文期刊>Engineering Geology >The impact of structure on the undrained shear strength of cohesive soils
【24h】

The impact of structure on the undrained shear strength of cohesive soils

机译:结构对粘性土不排水抗剪强度的影响

获取原文
获取原文并翻译 | 示例
           

摘要

The relationship between the undrained shear strength and the water content of cohesive soils can be described with a two parameter non-linear function. Parameter a is the water content at the undrained shear strength s_u = 1 kPa, and b is the slope of the linear function which represents the ratio between the water content logarithm and the undrained shear strength logarithm. These parameters depend mainly on the type and amount of clay minerals in the soils, the particle sizes and shapes, their arrangements, the forces between the clay particles, and the chemical composition of the pore water. The impact of quantity, type and size of clay grains on the water content at a uniform undrained shear strength in different soils has been studied previously, whilst the impact of structure is less understood. Particle associations and arrangements (i.e. fabric), and the interparticle forces determine the structure of soil. This paper focuses on an investigation of the relationship between water content and undrained shear strength in kaolinite samples with different structures. The various arrangements of clay particles that resulted from the changed of interparticle forces were obtained by salt addition (NaCl). Microfabrics of wet kaolinite samples were studied using a field emission scanning electron microscope. The results showed that clay structure exerts a strong influence on the relationship between the quantity of water and undrained shear strength. This was reflected in the values of both soil-dependent parameters, a and b. Values of parameter a varied between 39.16 percent and 62.96 percent, and b between 0.100 and 0.139, for well crystallized kaolinite with salt concentrations of 0-175 mmol/1. For poorly crystallized kaolinite with salt concentrations of 0-300 mmol/1, the values of a range between 46.96 percent and 100.30 percent, and b between 0.090 percent and 0.148 percent.
机译:不排水的抗剪强度与粘性土的含水量之间的关系可用两个参数的非线性函数来描述。参数a是不排水抗剪强度s_u = 1 kPa时的水含量,参数b是线性函数的斜率,表示水含量对数与不排水抗剪强度对数之间的比率。这些参数主要取决于土壤中粘土矿物的类型和数量,颗粒大小和形状,它们的排列,粘土颗粒之间的作用力以及孔隙水的化学成分。先前已经研究了粘土颗粒的数量,类型和大小对不同土壤中均匀不排水剪切强度下水分含量的影响,而对结构的影响却知之甚少。颗粒的结合和排列(即织物)以及颗粒间的力决定了土壤的结构。本文重点研究了不同结构的高岭土样品中水含量与不排水剪切强度之间的关系。通过添加盐分(NaCl)获得了由颗粒间作用力变化引起的粘土颗粒的各种排列。使用场发射扫描电子显微镜研究了湿高岭土样品的微结构。结果表明,黏土结构对水量与不排水抗剪强度之间的关系影响很大。这反映在两个与土壤相关的参数a和b的值上。对于盐浓度为0-175 mmol / 1的结晶良好的高岭石,参数a的值在39.16%和62.96%之间变化,b在0.100和0.139之间。对于盐浓度为0-300 mmol / 1的结晶度较差的高岭石,其取值范围为46.96%至100.30%,b的取值范围为0.090%至0.148%。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号