Influence of standardization on the precision (reproducibility) of dental cast analysis with virtual 3-dimensional models

摘要

Introduction: Virtual 3-dimensional (3D) models obtained by scanning of physical casts have become an alternative to conventional dental cast analysis in orthodontic treatment. If the precision (reproducibility) of virtual 3D model analysis can be further improved, digital orthodontics could be even more widely accepted. The purpose of this study was to clarify the influence of "standardization" of the target points for dental cast analysis using virtual 3D models. Physical plaster models were also measured to obtain additional information. Methods: Five sets of dental casts were used. The dental casts were scanned with R700 (3Shape, Copenhagen, Denmark) and REXCAN DS2 3D (Solutionix, Seoul, Korea) scanners. In this study, 3 system and software packages were used: SureSmile (OraMetrix, Richardson, Tex), Rapidform (Inus, Seoul, Korea), and IDEAS (SDRC, Milford, Conn). Results: Without standardization, the maximum differences were observed between the SureSmile software and the Rapidform software (0.39 mm +/- 0.07). With standardization, the maximum differences were observed between the SureSmile software and measurements with a digital caliper (0.099 mm +/- 0.01), and this difference was significantly greater (P<0.05) than the 2 other mean difference values. Furthermore, the results of this study showed that the mean differences "WITH" standardization were significantly lower than those "WITHOUT" standardization for all systems, software packages, or methods. Conclusions: The results showed that elimination of the influence of usability or habituation is important for improving the reproducibility of dental cast analysis.