...
首页> 外文期刊>The Astrophysical Journal. Letters >DYNAMICS OF TURBULENT CONVECTION AND CONVECTIVE OVERSHOOT IN A MODERATE-MASS STAR
【24h】

DYNAMICS OF TURBULENT CONVECTION AND CONVECTIVE OVERSHOOT IN A MODERATE-MASS STAR

机译:中等群众明星湍流对流与对流过冲的动态

获取原文
获取原文并翻译 | 示例
           

摘要

We present results of realistic three-dimensional (3D) radiative hydrodynamic simulations of the outer layers of a moderate-mass star (1.47 M-circle dot), including the full convection zone, the overshoot region, and the top layers of the radiative zone. The simulation results show that the surface granulation has a broad range of scales, from 2 to 12 Mm, and that large granules are organized in well-defined clusters, consisting of several granules. Comparison of the mean structure profiles from 3D simulations with the corresponding one-dimensional (1D) standard stellar model shows an increase of the stellar radius by similar to 800 km, as well as significant changes in the thermodynamic structure and turbulent properties of the ionization zones. Convective downdrafts in the intergranular lanes between granulation clusters reach speeds of more than 20 km s(-1), penetrate through the whole convection zone, hit the radiative zone, and form an 8Mm thick overshoot layer. Contrary to semi-empirical overshooting models, our results show that the 3D dynamic overshoot region consists of two layers: a nearly adiabatic extension of the convection zone and a deeper layer of enhanced subadiabatic stratification. This layer is formed because of heating caused by the braking of the overshooting convective plumes. This effect has to be taken into account in stellar modeling and the interpretation of asteroseismology data. In particular, we demonstrate that the deviations of the mean structure of the 3D model from the 1D standard model of the same mass and composition are qualitatively similar to the deviations for the Sun found by helioseismology.
机译:我们呈现实际三维(3D)辐射流体动力学模拟的中等质量恒星(1.47 m圆点)的外层,包括完整的对流区,过冲区域和辐射区域的顶层。仿真结果表明,表面造粒具有宽范围的鳞片,从2至12mm,大颗粒在明确定义的簇中组织,由几颗颗粒组成。从3D模拟与相应的一维(1D)标准恒星模型的平均结构谱的比较显示出类似于800公里的恒星半径的增加,以及电离区域的热力学结构和湍流性能的显着变化。在造粒簇之间的晶间通道中的对流下降速度达到20公里以上的速度(-1),穿过整个对流区,击中辐射区域,形成8mm厚的过冲层。与半经验过冲模型相反,我们的结果表明,3D动态过冲区域由两层组成:对流区的几乎绝热延伸和更深层次的次级分层层。该层是由于由过冲对流羽毛制动引起的加热而形成的。这种效果必须考虑在恒星建模和对星系症学数据的解释中。特别地,我们证明了3D模型的平均结构与相同质量和组成的1D标准模型的偏差与HelioSemology发现的太阳的偏差类似地类似。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号