首页> 外文期刊>Agricultural and Forest Meteorology >Modification of light-acclimation of Pinus sylvestris shoot architecture by site fertility
【24h】

Modification of light-acclimation of Pinus sylvestris shoot architecture by site fertility

机译:场地肥力对樟子松笋结构的光适应性的影响

获取原文
获取原文并翻译 | 示例
       

摘要

Adjustment of shoot architectural characteristics-needle angle with respect to shoot axis (a), needle mass per unit shoot silhouette area (M_s), needle number per unit shoot axis length (K_L), silhouette to total needle area ratio (S_s)-to seasonal average daily integrated quantum flux density (Q_(int)) was investigated in conifer Pinus sylvestris L. in an old field (fertile site) and in a raised bog (infertile site). For both sites, K_L increased with increasing Q_(int)?leading to a greater foliar area and dry mass per unit shoot length, as well as to larger MS and foliar nitrogen content per unit silhouette area at higher irradiance. The five-fold increase in MS with Q_(int) via architectural modifications allowed biomass concentration in high light environment where the photosynthetic returns were the highest. However, the negative correlations between 5s and Q_(int) indicated that enhanced needle production also led to a lower sunlit needle area fraction and greater self-shading within the shoot at higher irradiance. Simulations using canopy gap fractions across the sky hemisphere incident to the shoots in their natural position further demonstrated a decrease in light interception efficiency relative to a flat surf ace (nu) with increasing Q_(int). A shoot architectural model based on a turbid medium analogy suggested that the decreases in the efficiency primarily resulted from increased clumping and larger needle area density at higher irradiances. The relationships were qualitatively similar at both sites, but the needles were shorter and the packing of needles was higher leading to a lower gap fraction within the shoot volume and to greater self-shading within the shoot at the nutrient-limited site, especially under low irradiance. We conclude that both needle and shoot level modifications contribute to plastic alterations in shoot light harvesting efficiency in P. sylvestris, but also that site fertility may significantly constrain the light-acclimation in shoot architecture.
机译:调整拍摄结构特征-相对于拍摄轴的针角度(a),每单位拍摄轮廓面积的针质量(M_s),每单位拍摄轴长度的针数(K_L),轮廓与总针面积之比(S_s)-在旧田地(肥沃的地方)和凸起的沼泽地(不育地点)的针叶树樟子松中研究了季节平均日平均量子通量密度(Q_(int))。对于这两个地点,K_L随Q_(int)的增加而增加,这导致较大的叶面积和每单位苗长的干重,以及在较高辐照度下较大的MS和单位轮廓面积的叶氮含量。通过结构修饰,MS随Q_(int)的增加五倍,使生物量集中在光合作用最高的强光环境中。然而,5s与Q_(int)之间的负相关性表明,提高针的产量还导致较低的日光照射针面积分数和较高辐照度的芽内自阴影更大。使用跨越天空半球的自然位置入射到枝条的冠层间隙分数进行的模拟进一步证明,相对于平坦的表面(nu),随着Q_(int)的增加,光拦截效率会降低。一个基于混浊介质类比的芽建筑模型表明,效率降低主要是由于在较高辐照度下结块增加和针头面积密度增大所致。在两个部位上,这种关系在质量上相似,但是针头较短,针头堆积较高,从而导致在枝条内的空隙率较低,而在养分有限的部位,尤其是在低营养条件下,枝条内的自阴影更大。辐照度。我们得出的结论是,针叶和枝条水平的改变都有助于樟子松的枝条光采收效率的塑性变化,而且部位肥力可能会显着限制枝条结构中的光适应。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号