...
首页> 外文期刊>The journal of physical chemistry, B. Condensed matter, materials, surfaces, interfaces & biophysical >Impact of the Electrochemical Porosity and Chemical Composition on the Lithium Ion Exchange Behavior of Polypyrroles (ClO_4~-, TOS~-, TFSI~-) Prepared Electrochemically in Propylene Carbonate. Comparative EQCM, EIS and CV Studies
【24h】

Impact of the Electrochemical Porosity and Chemical Composition on the Lithium Ion Exchange Behavior of Polypyrroles (ClO_4~-, TOS~-, TFSI~-) Prepared Electrochemically in Propylene Carbonate. Comparative EQCM, EIS and CV Studies

机译:电化学孔隙度和化学组成对碳酸丙烯酯中电化学制备的聚吡咯(ClO_4〜-,TOS〜-,TFSI〜-)的锂离子交换行为的影响比较EQCM,EIS和CV研究

获取原文
获取原文并翻译 | 示例
   

获取外文期刊封面封底 >>

       

摘要

Conditions of electrodeposition, i.e. a potential window of the process, addition of water, the current density, and morphology of substrate electrodes (Pt, Pt/TiO2, Au), were shown to influence strongly ion-exchange properties of polypyrrole (PPy) synthesized in propylene carbonate (PC), doped with ClO_4~-~ or p-toluenesulfonate (TOS~-). "Electrochemical porosity" and redox activity of PPy films were compared to the characteristics of poly(3,4-ethylenedioxythiophene) (PEDOT). A molecular indicator of the PPy film structure packing was bis(trifluoromefhylsulfonyl)imide anion (TFSI~-). Ion-exchange properties of PPy were found to be almost independent of chemical composition of the polymer, described in the literature as PPy(I), PPy(II), PPy(III). Instead, micro- and nanoscopic morphology of the polymer film and a molecular level packing of the polymer chains as well as the counterion nature are of the foremost importance. The polymer film structure/ properties are shown to change upon prolonged redox/ionic stimulations. Lithium exchange between PPy films and contacting phases (PC electrolyte, TiO2) proceeds in addition to the anion exchange, the latter being a dominant process under conditions of the reversible electrochemical p-doping of PPy, although diffusion coefficients of PC solvated lithium ions in PPy are higher than diffusion coefficients of perchlorate, p-toluenesulfonate or bis(trifluoromethylsulfonyl)imide anions. The highest flux of Li~+ ions into/out of the PPy phase takes place about —1.0 V vs Ag/Ag~+ which is clearly evidenced by the cathodic/anodic CV peaks. Cation transport phenomena can be analyzed independently from anion transport when observed at a longer time scale (low values of potential scan rate) as each prevails at different redox states of the polymer. However, in a shorter time scale (v ≥ 10 mV s~(-1)), the opposite fluxes of cations and anions were observed to interfere. Furthermore, a net uptake of propylene carbonate by the as grown PPy film occurs at initial cycles of the cation uptake causing irreversible swelling of the polymer phase. Mechanisms of the redox process and accompanying mass transport involving PPy films were investigated using comparatively three techniques: cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS) and electrochemical quartz crystal microbalance (EQCM).
机译:电沉积的条件,即过程的潜在窗口,加水,电流密度和基质电极的形态(Pt,Pt / TiO2,Au),显示出强烈影响合成的聚吡咯(PPy)的离子交换性能在碳酸亚丙酯(PC)中掺杂ClO 4-或对甲苯磺酸盐(TOS--)。将PPy膜的“电化学孔隙率”和氧化还原活性与聚(3,4-乙撑二氧噻吩)(PEDOT)的特性进行了比较。 PPy膜结构堆积的分子指示剂是双(三氟甲磺酰基)酰亚胺阴离子(TFSI-)。发现PPy的离子交换性质几乎与聚合物的化学组成无关,在文献中描述为PPy(I),PPy(II),PPy(III)。相反,聚合物膜的微观和纳米形态以及聚合物链的分子水平堆积以及抗衡离子性质是最重要的。聚合物膜的结构/性能显示在长时间的氧化还原/离子刺激下会发生变化。 PPy膜与接触相(PC电解质,TiO2)之间的锂交换除阴离子交换外还进行,后者是PPy可逆电化学p掺杂条件下的主要过程,尽管PC溶剂化的锂离子在PPy中的扩散系数高于高氯酸根,对甲苯磺酸根或双(三氟甲基磺酰基)酰亚胺阴离子的扩散系数。相对于Ag / Ag〜+,Li〜+离子进出PPy相的最大通量约为-1.0 V,这可以通过阴极/阳极CV峰清楚地证明。当在较长的时间范围内(电位扫描速率较低)观察到阳离子迁移现象时,可以独立于阴离子迁移进行分析,因为每种现象普遍存在于聚合物的不同氧化还原状态下。但是,在较短的时间范围内(v≥10 mV s〜(-1)),观察到相反的阳离子和阴离子通量会产生干扰。此外,在阳离子吸收的初始循环中,随着生长的PPy膜而发生的碳酸亚丙酯的净吸收,引起聚合物相的不可逆溶胀。使用相对三种技术研究了涉及PPy膜的氧化还原过程及其伴随的质量迁移的机理:循环伏安法(CV),电化学阻抗谱(EIS)和电化学石英晶体微量天平(EQCM)。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号