首页> 外文期刊>日本食品科学工学会誌 >Cross-flow filtration of soy sauce sediment with rotating disk membrane module and agitated disk membrane module [Japanese]
【24h】

Cross-flow filtration of soy sauce sediment with rotating disk membrane module and agitated disk membrane module [Japanese]

机译:利用旋转盘式膜组件和搅拌式盘式膜组件错流过滤酱油沉淀物[日语]

获取原文
获取原文并翻译 | 示例
           

摘要

The cross-now micro-filtration performances of two kind of ceramic membrane modules, the rotating disk membrane module (RD module) and the agitated disk membrane module (AD module), were compared in this paper in the recovery process of soy sauce from soy sauce sediment, i.e. soy sauce sediment concentration process. Pseudo-plastic fluid characteristics of the concentrated soy sauce sediment cause a problem when the rotating is stopped suddenly by electricity failure, and so on. The RD module and AD module had lower pressure drop of the membrane modules than the conventional multi-tubular membrane module (MT module), so they could be operated at higher shear velocity under lower pressure deference across the membrane. Also, AD module had superior permeate flux to that of RD module at the same rotation rate of the rotor by the effect of both its impeller shape and the clearance between membrane and the impeller. That of RD module, however, hardly depended upon the baffle shape and the clearance between the membrane and the baffle. The permeate of AD module had good quality as soy sauce because of shorter processing time depending upon higher flux without qualitative change. The yield of soy sauce from raw soy sauce was estimated to be 99.7% by application of AD module instead of 80% of traditional process. It was concluded that AD module was the best membrane module to condense suspension from lower viscosity to higher one among the modules and other polymer membrane modules In terms of soy sauce quality, higher permeate flux, and lower pressure drop.
机译:本文比较了从酱油中回收酱油过程中两种陶瓷膜组件的交叉微滤性能,即旋转盘膜组件(RD模块)和搅拌盘膜组件(AD模块)。酱油沉淀物,即酱油沉淀物浓缩过程。浓缩酱油沉淀物的假塑性流体特性会在停电等突然停止旋转等情况时产生问题。与常规的多管式膜组件(MT模块)相比,RD模块和AD模块的膜组件具有更低的压降,因此它们可以在较低的压力作用下以较高的剪切速度在整个膜上运行。同样,在转子的相同转速下,AD模块的渗透通量比RD模块的渗透通量要好于其叶轮形状和膜与叶轮之间的间隙。然而,RD模块的尺寸几乎不取决于挡板的形状以及膜与挡板之间的间隙。 AD模块的渗透液作为酱油具有良好的品质,因为其加工时间较短,取决于较高的通量,而无定性变化。通过使用AD模块而不是传统工艺的80%,从生酱油中获得的酱油产率估计为99.7%。得出结论,就酱油质量,较高的渗透通量和较低的压降而言,AD模块是将模块中的低粘度悬浮液凝结成较高粘度的最佳膜组件,而其他聚合物膜组件则是如此。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号