...
首页> 外文期刊>Journal of the American Society for Mass Spectrometry >Direct Atmospheric Pressure Chemical Ionization-Tandem Mass Spectrometry for the Continuous Real-Time Trace Analysis of Benzene, Toluene, Ethylbenzene, and Xylenes in Ambient Air
【24h】

Direct Atmospheric Pressure Chemical Ionization-Tandem Mass Spectrometry for the Continuous Real-Time Trace Analysis of Benzene, Toluene, Ethylbenzene, and Xylenes in Ambient Air

机译:直接大气压化学电离串联质谱法对环境空气中的苯,甲苯,乙苯和二甲苯进行连续实时痕量分析

获取原文
获取原文并翻译 | 示例
           

摘要

Real-time monitoring of benzene, toluene, ethylbenzene, and xylenes (BTEX) in ambient air is essential for the early warning detection associated with the release of these hazardous; chemicals and in estimating the potential exposure risks to humans and the environment. We have developed a tandem mass spectrometry (MS/MS) method for continuous real-time determination of ambient trace levels of BTEX. The technique is based on the sampling of air via an atmospheric pressure inlet directly into the atmospheric pressure chemical ionization (APCI) source. The method is linear over four orders of magnitude, with correlation coefficients greater than 0.996. Low limits of detection in the range 1-2 mu g/m(3) are achieved for BTEX. The reliability of the method was confirmed through the evaluation of quality parameters such as repeatability and reproducibility (relative standard deviation below 8%, and 10%, respectively) and accuracy (over 95%). The applicability of this method to real-world samples was evaluated through measurements of BTEX levels in real ambient air samples and results were compared with a reference GC-FID method. This direct APCI-MS/MS method is suitable for real-time analysis of BTEX in ambient air during regulation surveys as well as for the monitoring of industrial processes or emergency situations.
机译:实时监测环境空气中的苯,甲苯,乙苯和二甲苯(BTEX)对于与这些有害物质释放相关的预警检测至关重要;化学品以及估计对人类和环境的潜在暴露风险。我们已经开发了一种串联质谱(MS / MS)方法,用于连续实时测定BTEX的环境痕量水平。该技术基于通过大气压入口直接进入大气压化学电离(APCI)源的空气采样。该方法在四个数量级上是线性的,相关系数大于0.996。 BTEX的检测下限达到1-2μg / m(3)。通过评估质量参数,例如重复性和可重复性(相对标准偏差分别低于8%和10%)和准确性(超过95%),证实了该方法的可靠性。通过测量实际环境空气样品中的BTEX含量,评估了该方法对实际样品的适用性,并将结果与​​参考GC-FID方法进行了比较。这种直接的APCI-MS / MS方法适用于在法规调查期间对环境空气中的BTEX进行实时分析,以及用于监视工业过程或紧急情况。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号