...
首页> 外文期刊>Carbon: An International Journal Sponsored by the American Carbon Society >Low-temperature synthesized nitrogen-doped iron/iron carbide/partly-graphitized carbon as stable cathode catalysts for enhancing bioelectricity generation
【24h】

Low-temperature synthesized nitrogen-doped iron/iron carbide/partly-graphitized carbon as stable cathode catalysts for enhancing bioelectricity generation

机译:低温合成氮掺杂铁/碳化铁/部分石墨化碳作为稳定的阴极催化剂,可增强生物发电能力

获取原文
获取原文并翻译 | 示例
           

摘要

Low efficiency of oxygen reduction reaction (ORR) across cathode interfaces constitutes an obstacle to the bioelectricity generation in microbial fuel cells (MFCs). Advances in the property of carbon-based catalysts for ORR will have far-reaching implications for MFCs. Melamine is used as both carbon and nitrogen sources for preparing nitrogen-doped Fe-species/partly-graphitized carbon (Fe-species/NPGq catalysts at relatively low temperature (640-700 degrees C). Main crystalline phases in Fe-species/NPGC-x (x = 640, 650, 660 and 700) change from iron carbide (Fe(3)G) to alpha-Fe as temperature increases. The O-C=O groups and structurally-bonded nitrogen (Fe-bonded N, pyridinic N and pyrrolic N) in PGC skeleton are favorable for improving electrical conductivity and catalytic activity. Single chamber MFCs with Fe/Fe3C/NPGC-650 generate power density of 1323 mW m(-2), which is higher than those of Fe-species/NPGC-x (x = 640, 660 and 700) and Pt/C (1191 mW m(-2)). Minimum power density decline (1.75%) is achieved by Fe/NPGC-660, which is far lower than that (17.11%) of Pt/C. The highest coulombic efficiency (30%) is obtained by Fe/Fe3C/NPGC-650 due to the sufficient active-sites (embedded Fe3C or Fe-N species) and easy charge transport across the triphase interfaces, which are conducive to "capture-consume" the electrons for catalyzing ORR. (C) 2015 Elsevier Ltd. All rights reserved.
机译:跨阴极界面的氧还原反应(ORR)效率低,是微生物燃料电池(MFCs)产生生物电的障碍。碳基ORR催化剂性能的进步将对MFC产生深远的影响。三聚氰胺既可作为碳源也可作为氮源,用于制备氮掺杂的Fe物种/部分石墨化碳(Fe物种/ NPGq催化剂,温度较低(640-700摄氏度)。Fe物种/ NPGC中的主要晶相-x(x = 640、650、660和700)随着温度的升高从碳化铁(Fe(3)G)变为α-Fe。OC = O基团和结构键合的氮原子(Fe键合的N,吡啶基N PGC骨架中的N和吡咯N)有利于提高电导率和催化活性。具有Fe / Fe3C / NPGC-650的单室MFC的功率密度为1323 mW m(-2),高于Fe物种/ NPGC-x(x = 640、660和700)和Pt / C(1191 mW m(-2))。Fe / NPGC-660的最小功率密度下降(1.75%),远低于( Pt / C的17.11%。由于足够的活性位点(嵌入的Fe3C或Fe-N物种)和易于在三叶核之间进行电荷转移,Fe / Fe3C / NPGC-650可获得最高的库仑效率(30%)。这些界面,有利于“捕获”用于催化ORR的电子。 (C)2015 Elsevier Ltd.保留所有权利。

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号