首页> 外文期刊>Water Science and Technology >The vortex concentrator for suspended solids treatment
【24h】

The vortex concentrator for suspended solids treatment

机译:用于悬浮物处理的涡流浓缩器

获取原文
获取原文并翻译 | 示例
           

摘要

The use of vortex concentrators is becoming increasingly popular for suspended solids reduction in combined sewer overflows and stormwater. This study is a laboratory investigation of the use of vortex concentrators to reduce the solids concentration of synthesized stormwater. The synthesized stormwater was made with water and addition of particles; sand, granular activated carbon, and sewer sediments. The vortex concentrator was made of acryl resin 300 mm in diameter. To determine the efficiency for various influent suspended solids (SS) concentrations, tests were performed with different SS concentrations. The samples were taken simultaneously at the influent storage tank and effluent tank, and measured SS concentrations. The range of surface loading rates were 120 to 850 m(3)/m(2)/day, and influent SS concentrations were varied from 300 to 5,000 mg/L. To determine the optimum coagulant dosage, jar tests were conducted with coagulants such as PAM and PAC. It was found that optimum coagulant and its dosage were PAM and 2 mg/L. The overall SS removal efficiency of the vortex concentrator for typical stormwater was estimated at about 65%. With an,increase of SS concentration, the removal efficiency was increased. Since the SS concentration of stormwater was higher than 1,000 mg/L, the removal efficiency of the vortex concentrator for stormwater could be estimated to be 65-70%. The SS removal; efficiency was increased with an increase of retention time, and the optimum retention time was 0.15-1.0 minutes. With an increase of the foul to overflow Q(F)/Q(o), a key parameter for vortex concentrator operation, the removal efficiency was increased. An alternative solution to improve treatment efficiency might be to set a follow-up retention basin. Based on a series of settling tests on the treated overflow water from the vortex concentrator, 5 to 10 minutes hydraulic retention time in a follow-up retention basin would substantially improve the results. [References: 10]
机译:对于减少下水道溢流和雨水混合中的悬浮物,涡流浓缩器的使用正变得越来越普遍。这项研究是对使用涡流浓缩器降低合成雨水固体浓度的实验室研究。用水和添加的颗粒制得的合成雨水;沙子,颗粒状活性炭和下水道沉淀物。涡旋浓缩器由直径为300mm的丙烯酸树脂制成。为了确定各种进水悬浮物(SS)浓度的效率,对不同SS浓度进行了测试。在进水储水箱和出水水箱中同时采集样品,并测量SS浓度。表面负荷率的范围是120至850 m(3)/ m(2)/天,进水SS浓度从300至5,000 mg / L不等。为了确定最佳混凝剂剂量,对混凝剂(例如PAM和PAC)进行了广口瓶测试。发现最佳混凝剂及其用量为PAM和2 mg / L。对于典型的雨水,旋流浓缩器的总SS去除效率估计约为65%。随着SS浓度的增加,去除效率提高。由于雨水的SS浓度高于1,000 mg / L,因此涡流浓缩器对雨水的去除效率估计为65-70%。 SS去除;效率随着保留时间的增加而增加,最佳保留时间为0.15-1.0分钟。随着溢流口Q(F)/ Q(o)(涡流浓缩器运行的关键参数)的结垢率增加,去除效率提高。提高治疗效率的另一种解决方案可能是建立一个后续保留盆。根据对来自涡流浓缩器的处理过的溢水的一系列沉降测试,在后续保留池中进行5至10分钟的水力停留时间将大大改善结果。 [参考:10]

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号