首页> 外文期刊>The European physical journal. Applied physics >Annealing and thickness effect on the optical absorption of Ge_(20)Te_(80) and Cu_6Ge_(14)Te_(80) films
【24h】

Annealing and thickness effect on the optical absorption of Ge_(20)Te_(80) and Cu_6Ge_(14)Te_(80) films

机译:退火和厚度对Ge_(20)Te_(80)和Cu_6Ge_(14)Te_(80)薄膜的光吸收的影响

获取原文
获取原文并翻译 | 示例
           

摘要

Thin films of Ge_(20)Te_(80) and Cu_6Ge_(14)Te_(80) of different thicknesses are deposited on glass substrate by thermal evaporation under vacuum. The effect of incorporation of copper in Ge_(20)Te_(80) film is studied by measuring the optical absorption. The mechanism of optical absorption follows the rule of direct transition. The films are annealed at different elevated temperatures from 370 to 520 K. The measurements were carried on as-deposited and annealed specimens. The optical energy gap (E_g) was found to decrease with increasing the annealing temperatures in the case of Ge_(20)Te_(80) films. But in the case of Cu_6Ge_(14)Te_(80) films, E_g first increases with annealing temperature up to 410 K, then decreases sharply after further increasing the annealing temperature above the glass transition temperature. The decreases of E_g and the increase of the width of localized states E_e could be attributed to the amorphous - crystalline transformation. The values of optical energy gap E_g are also found to increase with thickness of both two-type films. The effect of films thickness on optical energy gap (E_g) of the films is interpreted in terms of the density of state model of Mott and Davis. The refractive index n, extinction coefficient k and dielectric constant ε_i and ε_r are also calculated for all samples.
机译:通过在真空下热蒸发在玻璃基板上沉积厚度不同的Ge_(20)Te_(80)和Cu_6Ge_(14)Te_(80)薄膜。通过测量光吸收率研究了铜在Ge_(20)Te_(80)膜中的掺入作用。光吸收的机理遵循直接跃迁的规律。薄膜在370至520 K的不同高温下退火。测量是在沉积和退火的样品上进行的。在Ge_(20)Te_(80)膜的情况下,发现光能隙(E_g)随着退火温度的升高而减小。但是,在Cu_6Ge_(14)Te_(80)薄膜的情况下,E_g首先随着退火温度升高到410 K而增加,然后在将退火温度进一步提高到玻璃化转变温度之上之后急剧下降。 E_g的减少和局部态E_e的宽度的增加可以归因于非晶-晶体转变。还发现光能隙E_g的值随着两种类型的膜的厚度而增加。膜厚度对膜的光学能隙(E_g)的影响用莫特和戴维斯的状态模型密度来解释。还针对所有样品计算折射率n,消光系数k以及介电常数ε_i和ε_r。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号