Near-Surface Shear-Wave Velocity Measurements in Unlithified Sediment.

摘要

Shear-wave (S-wave) velocity can be directly correlated to material stiffness making it a valuable physical property that has found uses in construction, engineering, and environmental projects. This study compares three different methods, Multichannel Analysis of Surface Waves (MASW), S-wave tomography, and downhole seismic for measuring S-wave velocities, investigates and identifies the differences among the methods' results, and prioritizes the different methods for S-wave use at the U. S. Army's Yuma Proving Grounds (YPG) north of Yuma, AZ. A large signal-to-noise ratio and a layered depositional architecture at the study site gives the MASW method much potential, but higher-mode energy resulting from velocity discontinuities reduces the effectiveness of the method shallower than 20 ft. First arrival analysis provides evidence of a velocity discontinuity within the first 10 feet of unconsolidated sediment. S-wave first arrivals were picked using impulsive sledgehammer data which were then used for both tomographic inversion and refraction analysis. Three-component downhole seismic data were collected by using a locking geophone coupled with the borehole casing to estimate seismic velocities directly. This study helps to identify the strengths and weaknesses of each of these methods at sites similar to YPG. MASW results show a low-velocity layer at a depth of about 50 feet that is verified by downhole seismic data and is undetectable through traditional refraction tomography. However S-wave refraction tomography provides more convincing results at shallow depths where the MASW method fails. Using both methods in an integrated fashion provide the most accurate depiction of S-wave velocity characteristics in the shallow unconsolidated sediments at YPG.