首页> 外文会议>Fifth International Conference on Durability Analysis of Composite Systems, Nov 6-9, 2001, Tokyo, Japan >Dependence of time, temperature and water absorption on flexural strength of CFRP laminate
【24h】

Dependence of time, temperature and water absorption on flexural strength of CFRP laminate

机译:时间,温度和吸水率对CFRP层压板弯曲强度的依赖性

获取原文
获取原文并翻译 | 示例

摘要

This paper is concerned with the influence of water absorption on the time-temperature dependent flexural strength of CFRP laminates. The CFRP laminates were prepared under three conditions of "Dry", "Wet" and "Wet + Dry". The "Dry" laminates by holding the cured laminates in the oven at 150℃x2hours, the "Wet" laminates by soaking the "Dry" laminates in hot water at 95℃x48hours, and the "Wet + Dry" laminates by dehydrating the "Wet" laminates in the oven at 150℃x2hours were respectively prepared. The three-point bending tests for these three kinds of CFRP laminates were carried out under various constant strain rates (CSR) and temperatures. The time-temperature dependence of flexural CSR strength of these CFRP laminates were obtained and the influence of water absorption on these strength were discussed. As results, it was cleared that the remarkable influence of water absorption on these strength exists and that this influence is separated into two parts by reversible and irreversible damages.
机译:本文关注吸水率对CFRP层压板时温依赖性弯曲强度的影响。 CFRP层压板是在“干”,“湿”和“湿+干”三种条件下制备的。通过将固化后的层压板在烤箱中保持150℃x 2小时的温度来干燥“干”层压板,将“干燥”层压板在95℃x 48小时的热水中浸泡,将“湿”层压板,通过将“分别在150℃×2小时的烘箱中制备湿的层压材料。这三种CFRP层压板的三点弯曲试验是在各种恒定应变率(CSR)和温度下进行的。获得了这些CFRP层压板挠曲CSR强度的时间-温度依赖性,并讨论了吸水率对这些强度的影响。结果,清楚了存在吸水对这些强度的显着影响,并且该影响被可逆和不可逆损坏分为两部分。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号