...
首页> 外文期刊>International journal of engine research >Ignition, lift-off, and soot formation studies in n-dodecane split injection spray-flames
【24h】

Ignition, lift-off, and soot formation studies in n-dodecane split injection spray-flames

机译:N-十二烷分离喷射喷雾火焰中的点火,剥离和烟灰形成研究

获取原文
获取原文并翻译 | 示例
           

摘要

A close-coupled double injection strategy with two 0.5-ms injections separated by a 0.5-ms dwell is implemented. Studies are performed in a constant volume pre-burn type combustion vessel over two ambient temperatures (900 and 800 K) at constant density (22.8 kg/m(3)) with 15% O-2 by volume in the ambient. The aim of this work is to investigate the establishment and dependence of ignition delay and flame stabilization on the ambient temperature conditions especially for the main injection, and thereby investigating eventual soot production. Simultaneous schlieren and planar laser induced fluorescence experiments as well as three-dimensional Reynolds-averaged numerical simulation computational fluid dynamic modeling with chemical kinetics in every computational fluid dynamic cell were performed. It was observed experimentally that at 900 K, the second injection is injected in a high-temperature combustion recessed ambient of the first injection whereas at 800 K it is injected in a low temperature, possibly reactive species environment. It was found from Reynolds-averaged numerical simulation modeling that combustion recession at 900 K in the present case entails rich presence of hydroxyl radical species and also the ambient of 800 K is source of reactive radicals like peroxides, leading to acceleration of main ignition. Flame stabilization of the second injection occurs closer to the injector due to short ignition delays with flame being sustained in the fuel-air premixing zone. Flame stabilization of the second injection was found to follow a premixed flame propagation mechanism. Investigation in mixture fraction and temperature space of pilot-main spray combustion revealed that the lower lift-off of main results in lower air-entrainment which causes richer ignition of main resulting in quicker and higher soot formation. The effect of the second injection in enhancing the oxidation of soot from the first injection by inducing enhanced mixing was also revealed.
机译:实施了牢固的双注射策略,具有由0.5 - MS停留分离的两个0.5ms注射。在恒定密度(22.8kg / m(3))的两个环境温度(900和800k)上在恒定体积预燃烧型燃烧容器中进行研究,在环境温度下含15%O-2的体积。这项工作的目的是调查点火延迟和火焰稳定对环境温度条件的建立和依赖性,特别是对于主要注射,从而调查最终烟灰生产。进行同时施洛森和平面激光诱导的荧光实验以及在每个计算流体动态电池中与化学动力学的三维雷诺平均数值计算流体动态建模。实验观察到,在900 k下,第二喷射在高温燃烧中注射第一次注射的凹陷环境,而在800 k下,它被注入低温,可能的反应物种环境。从Reynolds平均数值模拟建模中发现,目前情况下900 K的燃烧衰退需要富含羟基的物质,并且800 k的环境也是过氧化物的反应性自由基的来源,导致主点火加速。由于在燃料 - 空气预混合区中持续的火焰的短点火延迟短点火延迟,第二喷射的火焰稳定发生在喷射器上更靠近喷射器。发现第二注射的火焰稳定化遵循预混火焰繁殖机制。导频主喷涂燃烧混合级分和温度空间的研究表明,主要的升降次数导致较低的空气夹带导致主要点火导致较快的烟雾形成。还揭示了通过诱导增强混合从第一注射增强烟灰氧化的第二注射的效果。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号