Electrical Facility Effects on Hall Thruster Cathode Coupling: Performance and Plume Properties

摘要

The impact of facility conductivity on Hall effect thruster cathode coupling is experimentally investigated. The 3.4 kW Aerojet Rocketdyne T-140 Hall effect thruster operating at a discharge voltage of 300 V, a discharge current of 10.3 A, and an anode flow rate of 11.6 mg/s serves as a representative Hall effect thruster test bed. The nominal facility operating pressure during thruster operation is 7.3 × 10~(-6) Torr corrected for xenon. Two 0.91 × 0.91 m square aluminum plates are placed adjacent to, but electrically isolated from, the walls of the conductive vacuum chamber at two locations with respect to the center of the thruster exit plane: 4.3 m axially downstream along the thruster centerline, and 2.3 m radially outward centered on the exit plane. The plates and body of the Hall effect thruster are configured in three distinct electrical configurations with corresponding measurements: 1) electrically grounded with measurements of currents to ground, 2) electrically isolated with measurements of floating voltages, and 3) isolated from ground but electrically connected with measurements of the current conducted between the plates. Measurements are taken as the radial position of the cathode is varied from 0 to 129 cm with respect to the nominal cathode location. Measurements of the current collected by the plates and thruster body indicate that cathode electrons preferentially travel to the thruster body, Hall effect thruster plume, and radial facility surfaces for cathode locations in the near field, midfield, and far field, respectively. These results indicate that cathode position alters the recombination pathways taken by cathode electrons in the Hall effect thruster circuit.