Standardization of the method of magnetostriction measurement of grain-oriented electrical steel strip and sheet

摘要

Standardization of the method of measurement of AC magnetostriction characteristics of grain-oriented electrical steel strip and sheet by means of a single sheet tester and an optical sensor, i.e. IEC 60404-17 Ed.l [1], has been promoted in the 1EC/TC68/WG2 to meet the demand of transformer industry. The relationship between the magnetostriction characteristics of grain-oriented electrical steel and transformer noise is complicated and yet not fully understood. One of basic problems has been the lack of a standard for the magnetostriction measurements. The measurement requires detection of slight vibration of the test specimen at a resolution of 0.01 μm/m or better. In order to ensure this resolution, not only magnetic aspects but also mechanical aspects of the test apparatus, e.g. the influence of friction and external vibrations, have to be specified. The size of test specimen is restricted to 100 mm × 500 mm. The flux closer is a vertical single yoke or a horizontal double yoke. In order to avoid the influence of friction and vibration, no weight is put on the test specimen except an optical target and a clamp to fix the test specimen to the test apparatus. Also, no weight is connected to the end of test specimen to prevent additional vibration modes. The optical target is low mass and made of non-magnetic and non-conductive materials. The optical target and the clamp are placed between opposite pole faces of the yoke. In order to realize a low and constant friction coefficient, an insertion sheet with a thin fluorine resin-impregnated glass cloth adhesive film on its upper surface is placed under the test specimen. A round robin comparison using different test setups in accordance with the draft of standard was carried out.