...
首页> 外文期刊>Journal of Cleaner Production >Environmental aspects of converting municipal solid waste into energy as part of composite fuels
【24h】

Environmental aspects of converting municipal solid waste into energy as part of composite fuels

机译:将城市固体废物作为复合燃料的一部分转化为能源的环境方面

获取原文
获取原文并翻译 | 示例
           

摘要

The paper outlines the results of the experimental research into the ignition and combustion of composite liquid fuel with fine-grained particles of municipal solid wastes (MSW) added as a solid fuel component: wood, rubber, plastic, and cardboard. A relatively low concentration (about 10 wt%) of these components in the fuel intensifies the ignition process, given that all other conditions are the same. The experimental research has been performed using two experimental setups. The first setup allows for researching the conditions of radiant heating of motionless fuel droplets (about 1 mm in size) in a muffle furnace when the temperature is in the range of 400-1000 degrees C. The second setup allows for implementing the conditions of convective heating of motionless fuel droplets (about 1 mm in size) in the flow of pre-heated air (at the rate of 3 m/s and the temperature in the range of 400-700 degrees C). The research findings include minimum temperatures required for the stable ignition of composite liquid fuel with added MSW. They also include the dependencies of ignition delay times on the temperature under different heating conditions. It has also been determined that fuels with MSW are notable for lower nitrogen oxide and sulfur oxide concentrations in gaseous combustion products as compared to fuels without municipal wastes. Maximum difference in the concentrations of NOx and SOx for such fuels reaches 70% and 45% (in absolute units, 125 ppm and 50 ppm, respectively). The results of analytical calculations of relative fuel performance coefficients provide good reasons for the prospective use of such compositions in thermal power engineering. These relative coefficients took values in the range of 1-3. The results obtained provide ground for developing a disposal technology for MSW that cannot be processed or recycled. The technology must be power-efficient as well as economically efficient and environmentally friendly. (C) 2018 Elsevier Ltd. All rights reserved.
机译:本文概述了复合液体燃料着火和燃烧的实验研究结果,其中添加了细颗粒的城市固体废物(MSW)作为固体燃料成分:木材,橡胶,塑料和纸板。假设所有其他条件都相同,则燃料中这些成分的浓度相对较低(约10 wt%)会增强点火过程。已经使用两个实验装置进行了实验研究。第一种设置允许研究马弗炉中温度在400-1000摄氏度范围内的静止燃料滴(尺寸约1毫米)的辐射加热条件。第二种设置允许实现对流条件在预热的空气流中加热静止的燃料液滴(大小约为1毫米)(速率为3 m / s,温度范围为400-700摄氏度)。研究结果包括添加MSW稳定点燃复合液体燃料所需的最低温度。它们还包括点火延迟时间对不同加热条件下温度的依赖性。还已经确定,与不含城市垃圾的燃料相比,具有MSW的燃料在气态燃烧产物中的氮氧化物和硫氧化物浓度较低。这类燃料的NOx和SOx浓度最大差异达到70%和45%(以绝对单位分别为125 ppm和50 ppm)。相对燃料性能系数的分析计算结果为在火力工程中预期使用此类成分提供了充分的理由。这些相对系数取值为1-3。获得的结果为开发无法处理或回收的城市固体废弃物处理技术奠定了基础。该技术必须具有高能效,经济高效和环保的特点。 (C)2018 Elsevier Ltd.保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号