首页> 外文期刊>IEICE Transactions on Electronics >A Low Distortion and Low Noise Differential Amplifier Suitable for 3G LTE Applications Using the Even- and Odd-Mode Impedance Differences of a Bias Circuit
【24h】

A Low Distortion and Low Noise Differential Amplifier Suitable for 3G LTE Applications Using the Even- and Odd-Mode Impedance Differences of a Bias Circuit

机译:使用偏置电路的偶模和奇模阻抗差的低失真,低噪声差分放大器,适用于3G LTE应用

获取原文
获取原文并翻译 | 示例
           

摘要

A low distortion and low noise differential amplifier using the difference between the even- and odd-mode impedances is proposed. In order to realize an amplifier with high OIP3 and low NF characteristics, the impedance of the bias circuit should be low (< 300 Ω) at the difference frequency and high (> 4 kΩ) at the carrier frequency. Although the frequency response of the bias circuit impedance can only meet these conditions with difficulty, owing to the 20 MHz Tx signal bandwidth for 3G LTE, the proposed amplifier can achieve the impedance difference using the properties of a differential configuration where the difference frequency signal is the even-mode and the carrier frequency is the odd-mode. It has been demonstrated that the NF of the proposed amplifier, which has been fabricated in 0.18 μm SiGe BiCMOS technology operating at 2.14 GHz, can be kept to 1.6 dB or less and an OIP3 of 9.0 dBm can be achieved, which is 3 dB higher than that of a conventional amplifier, in the condition where the power gain is greater than 18 dB.
机译:提出了一种利用偶模阻抗和奇模阻抗之间的差异的低失真和低噪声差分放大器。为了实现具有高OIP3和低NF特性的放大器,偏置电路的阻抗在差频时应低(<300Ω),在载频时应高(> 4kΩ)。尽管偏置电路阻抗的频率响应仅能困难地满足这些条件,但由于3G LTE的Tx信号带宽为20 MHz,建议的放大器可以利用差分配置的特性来实现阻抗差分,其中差分频率信号为偶数模式和载波频率是奇数模式。已经证明,采用0.18μmSiGe BiCMOS技术制造的拟议放大器的NF可以保持在2.14 GHz,并且可以保持在1.6 dB或更小,并且可以实现9.0 dBm的OIP3,这要高3 dB。在功率增益大于18 dB的情况下,它比常规放大器要大。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号