首页> 外文期刊>E3S Web of Conferences >Commissioning Measurements of Electron Beam Using Montecarlo Algorithm on Truebeam STx? and Compariaon with Clinac iX Linear Accelerator
【24h】

Commissioning Measurements of Electron Beam Using Montecarlo Algorithm on Truebeam STx? and Compariaon with Clinac iX Linear Accelerator

机译:在Truebeam STX上使用Montecarlo算法调试电子束的测量? 并与Clarac IX线性加速器的比较

获取原文
           

摘要

TrueBeam STx latest generation linear accelerators (linacs) installed at Sheikh Khalifa International University Hospital in Casablanca, Morocco.The aim of this is to present and compare the result of the Electron commissioning measurement on TrueBeam Stx and clinac iX installed at Sheikh Khalifa International University Hospital in Casablanca, Morocco. A compariaon of eMC calculations and measurements for TrueBeam Stx were evaluated.Dosimetric parameters are systematically measured using a large water phantom 3D scanning system MP3 Water Phantom (PTW, Freiburg, Germany). The data of the electron beams commissioning including depth dose curves for each applicator, depth dose curves without applicator and the profile in air for a large field size 40x 40cm~(2), and the Absolute Dose (cGy/MU) for each applicator. All the data were examined and compared for five electron beams (E6MeV, E9MeV, E12MeV, E16MeV and E20MeV) of Varian’s TrueBeam STx and Clinac iX machines.A comparison, between measurement PDDs and calculated by the Eclipse electron Monte Carlo (eMC) algorithm were performed to validate Truebeam Stx commissioning. All this measurements were performed with a Roos and Markus plane parallel chamber.Our measured data indicated that electron beam PDDs from the TrueBeam Stx machine are well matched to those from our Varian Clinac iX machine.Significant differences between TrueBeam and Clinac iX were found in in‐air profiles and open field output. Maximum depth dose for the TrueBeam Stx and Clinac iX for the following energies (6, 9, 12, 16, 20 MeV) are respectively (1.15; 1.89; 2.6; 3.1; and 2.35) and (1.24; 1.95; 2.70; 2.99 and 2.4cm). For the TrueBeam Stx and Clinac iX the quality index R_(50)for applicator 15x15 cm~(2)are in the tolerance intervals. Surface dose increases by increasing energy for both machines.The Absolute Dose (cGy/MU) calibrated for both machine in D_(max)at 1cGy/MU for the reference field size cone 15x15 cm~(2).Bremsstrahlung tail Rp per energy levels as follows for the TrueBeam Stx : 6 MeV – 2.85 cm, 9 MeV – 4.28 cm, 12 MeV – 5.97 cm, 16 MeV – 7.88 cm and 20 MeV – 9.86 cm. and for theClinac iX : 6 MeV – 2.86 cm, 9 MeV – 4.32 cm, 12 MeV – 5.96 cm, 16 MeV – 7.93 cm and 20 MeV – 10.08 cm.A good agreement between modeled and measured data is observed.
机译:安装在哈利法国际大学附属医院在卡萨布兰卡TrueBeam STx中最新一代的直线加速器(直线加速器),Morocco.The目的的,这是存在和TrueBeam STX和clinac九中的电子调试测量安装在哈利法国际大学附属医院的结果比较在摩洛哥的卡萨布兰卡。 EMC计算和测量的用于TrueBeam的Stx甲compariaon是evaluated.Dosimetric参数是使用一个大的水体模3D扫描系统MP3水模体(PTW,弗赖堡,德国)系统测得的。电子的数据射束调试包括每个涂抹器深度剂量曲线,没有施加器的深度剂量曲线和大的场尺寸在空气中的轮廓40倍40厘米〜(2),以及绝对剂量戈瑞(cGy / MU)对于每个施加器。由Eclipse电子蒙特卡洛(EMC)算法进行检查的所有数据并比较瓦里安TrueBeam STX和Clinac的iX machines.A比较五个电子束(E6MeV,E9MeV,E12MeV,E16MeV和E20MeV),测量项目设计文件之间的和计算分别执行验证Truebeam的Stx调试。所有这些测量使用鲁斯和Markus平面平行chamber.Our测量数据指示执行从TrueBeam的Stx机器电子束项目设计文件良好匹配到那些从我们的TrueBeam和Clinac的iX之间瓦里安Clinac的iX machine.Significant差异中发现 - 空气型材和露地输出。为TrueBeam STX和Clinac iX被以下的能量(6,9,12,16,20兆电子伏)最大深度剂量分别为(1.15; 1.89; 2.6; 3.1;以及2.35)和(1.24; 1.95; 2.70; 2.99和2.4厘米)。对于TrueBeam STX和Clinac IX中的质量指数R_(50),用于涂敷器15×15厘米〜(2)是在公差区间。通过在1cGy / MU在D_(最大)校准二者机为参考字段大小15×15锥形厘米〜(2).Bremsstrahlung每尾的能量水平都卢比machines.The绝对剂量戈瑞(cGy / MU)增加能量表面剂量增加如下为TrueBeam的Stx:6兆电子伏 - 2.85厘米,9MeV的 - 4.28厘米,12MeV的 - 5.97厘米,16兆电子伏 - 7.88厘米和20兆电子伏 - 9.86厘米。和用于theClinac九:6兆电子伏 - 2.86厘米,9MeV的 - 4.32厘米,12MeV的 - 5.96厘米,16兆电子伏 - 7.93厘米和20兆电子伏 - 建模和测量的数据之间10.08 cm.A良好的一致性是观察。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号