首页> 外文期刊>Atmospheric Chemistry and Physics Discussions >Modeling ultrafine particle growth at a pine forest site influenced by anthropogenic pollution during BEACHON-RoMBAS 2011
【24h】

Modeling ultrafine particle growth at a pine forest site influenced by anthropogenic pollution during BEACHON-RoMBAS 2011

机译:在Beachon-Rombas 2011期间受到人为污染影响的松树森林遗址超细颗粒生长

获取原文
           

摘要

Formation and growth of ultrafine particles is crudely represented in chemistry-climate models, contributing to uncertainties in aerosol composition, size distribution, and aerosol effects on cloud condensation nuclei (CCN) concentrations. Measurements of ultrafine particles, their precursor gases, and meteorological parameters were performed in a ponderosa pine forest in the Colorado Front Range in July–August 2011, and were analyzed to study processes leading to small particle burst events (PBEs) which were characterized by an increase in the number concentrations of ultrafine 4–30 nm diameter size particles. These measurements suggest that PBEs were associated with the arrival at the site of anthropogenic pollution plumes midday to early afternoon. During PBEs, number concentrations of 4–30 nm diameter particles typically exceeded 104 cm?3, and these elevated concentrations coincided with increased SO2 and monoterpene concentrations, and led to a factor-of-2 increase in CCN concentrations at 0.5% supersaturation. The PBEs were simulated using the regional WRF-Chem model, which was extended to account for ultrafine particle sizes starting at 1 nm in diameter, to include an empirical activation nucleation scheme in the planetary boundary layer, and to explicitly simulate the subsequent growth of Aitken particles (10–100 nm) by condensation of organic and inorganic vapors. The updated model reasonably captured measured aerosol number concentrations and size distribution during PBEs, as well as ground-level CCN concentrations. Model results suggest that sulfuric acid originating from anthropogenic SO2 triggered PBEs, and that the condensation of monoterpene oxidation products onto freshly nucleated particles contributes to their growth. The simulated growth rate of ~ 3.4 nm h?1 for 4–40 nm diameter particles was comparable to the measured average value of 2.3 nm h?1. Results also suggest that the presence of PBEs tends to modify the composition of sub-20 nm diameter particles, leading to a higher mass fraction of sulfate aerosols. Sensitivity simulations suggest that the representation of nucleation processes in the model largely influences the predicted number concentrations and thus CCN concentrations. We estimate that nucleation contributes 67% of surface CCN at 0.5% supersaturation in this pine forest environment.
机译:超细颗粒的形成和生长在化学 - 气候模型中粗略地表示,有助于气溶胶组合物的不确定性,尺寸分布和气溶胶对云凝聚核(CCN)浓度的影响。在2011年7月至8月的科罗拉多州的柚子杉木林中进行超细颗粒,它们的前体气体和气象参数的测量,并分析了致力于小颗粒爆发事件(PBE)的过程的研究进程增加超细4-30nm直径粒子的数量浓度。这些测量表明,PBE与午后午后的人为污染羽毛的到来相关联。在PBE期间,4-30nm直径颗粒的数量浓度通常超过104cm?3,并且这些升高的浓度与升高的SO 2和单萜浓度一致,并导致CCN浓度增加0.5%过饱和的2倍。使用区域WRF-CHEM模型模拟PBE,其扩展到直径为1nm的超细粒度尺寸,以包括行星边界层的经验激活成核方案,并明确模拟AITKEN的随后生长通过有机和无机蒸汽冷凝颗粒(10-100nm)。更新的模型在PBE期间合理地捕获测量的气溶胶数浓度和尺寸分布,以及地面CCN浓度。模型结果表明,源自人为SO2触发PBE的硫酸,并将单萜氧化产物的缩合到新鲜核颗粒上有助于其生长。模拟的生长速率为4-40nm直径颗粒的〜3.4nm H 2〜4-40nm颗粒的测量平均值与2.3nm H 2的测量值相当。结果还表明,PBE的存在倾向于改变亚20nm直径颗粒的组成,导致硫酸盐气溶胶的较高质量分数。敏感性模拟表明模型中成核过程的表示在很大程度上影响预测数量浓度,从而影响CCN浓度。我们估计成核在该松林环境中为0.5%的过饱和度贡献了67%的表面CCN。

著录项

获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号