首页> 外文期刊>Journal of Modern Power Systems and Clean Energy >Faulty Feeder Identification and Fault Area Localization in Resonant Grounding System Based on Wavelet Packet and Bayesian Classifier
【24h】

Faulty Feeder Identification and Fault Area Localization in Resonant Grounding System Based on Wavelet Packet and Bayesian Classifier

机译:基于小波包和贝叶斯分类器的谐振接地系统中有缺陷的馈线识别和故障区域定位

获取原文
获取原文并翻译 | 示例
           

摘要

Accurate fault area localization is a challenging problem in resonant grounding systems (RGSs). Accordingly, this paper proposes a novel two-stage localization method for single-phase earth faults in RGSs. Firstly, a faulty feeder identification algorithm based on a Bayesian classifier is proposed. Three characteristic parameters of the RGS (the energy ratio, impedance factor, and energy spectrum entropy) are calculated based on the zero-sequence current (ZSC) of each feeder using wavelet packet transformations. Then, the values of three parameters are sent to a pre-trained Bayesian classifier to recognize the exact fault mode. With this result, the faulty feeder can be finally identified. To find the exact fault area on the faulty feeder, a localization method based on the similarity comparison of dominant frequency-band waveforms is proposed in an RGS equipped with feeder terminal units (FTUs). The FTUs can provide the information on the ZSC at their locations. Through wavelet-packet transformation, ZSC dominant frequency-band waveforms can be obtained at all FTU points. Similarities of the waveforms of characteristics at all FTU points are calculated and compared. The neighboring FTU points with the maximum diversity are the faulty sections finally determined. The proposed method exhibits higher accuracy in both faulty feeder identification and fault area localization compared to the previous methods. Finally, the effectiveness of the proposed method is validated by comparing simulation and experimental results.
机译:准确的故障区域定位是谐振接地系统(RGSS)中的一个具有挑战性的问题。因此,本文提出了一种用于RGSS中单相接地故障的新型两级定位方法。首先,提出了一种基于贝叶斯分类器的错误馈电识别算法。使用小波包变换的每个馈线的零序电流(ZSC)计算RGS(能量比,阻抗因子和能谱熵)的三个特征参数。然后,将三个参数的值发送到预先训练的贝叶斯分类器以识别确切的故障模式。通过这种结果,最终可以识别出故障的馈线。为了找到故障馈线上的确切故障区域,在配备有馈线终端单元(FTU)的RG中提出了基于主频带波形的相似性比较的定位方法。 FTU可以在其位置提供关于ZSC的信息。通过小波包变换,可以在所有FTU点获得ZSC主导频带波形。计算并比较所有FTU点处的特性波形的相似性。具有最大分集的邻近的FTU点是最终确定的故障部分。与以前的方法相比,该方法在错误的馈线识别和故障区域定位中表现出更高的准确性。最后,通过比较模拟和实验结果来验证所提出的方法的有效性。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号