...
首页> 外文期刊>Earthquake Science >Did the MS7.0 Lushan earthquake dynamically trigger earthquakes in the Datong volcanic region (Shanxi Province)?
【24h】

Did the MS7.0 Lushan earthquake dynamically trigger earthquakes in the Datong volcanic region (Shanxi Province)?

机译:大山火山区(山西省)的 M S 7.0地震是否动态触发了地震?

获取原文
           

摘要

Abstract Immediately following the M ~(S)7.0 Lushan earthquake on April 20, 2013, using high-pass and low-pass filtering on the digital seismic stations in the Shanxi Province, located about 870–1,452?km from the earthquake epicenter, we detected some earthquakes at a time corresponding to the first arrival of surface waves in high-pass filtering waveform. The earthquakes were especially noticed at stations in Youyu (YUY), Shanzizao (SZZ), Shanghuangzhuang (SHZ), and Zhenchuan (ZCH), which are located in a volcanic region in the Shanxi Province,but they were not listed in the Shanxi seismic observation report. These earthquakes occurred 4–50?min after the passage of the maximum amplitude Rayleigh wave, and the periods of the surface waves were mainly between 15 and 20?s following. The Coulomb stresses caused by the Rayleigh waves that acted on the four stations was about 0.001?MPa, which is a little lower than the threshold value of dynamic triggering, therefore, we may conclude that the Datong volcanic region is more sensitive to the Coulomb stress change. To verify, if the similar phenomena are widespread, we used the same filtering to observe contrastively continuous waveform data before, and 5?h after, the M ~(S)7.0 Lushan earthquake and M ~(S)9.0 Tohoku earthquake in 2011. The results show that the similar phenomena occur before the earthquakes, but the seismicity rates after the earthquakes are remarkably increased. Since these weak earthquakes are quite small, it is hard to get clear phase arrival time from three or more stations to locate them. In addition, the travel time differences between P waves and S waves (S–P) are all less than 4?s, that means the events should occur in 34?km around the stations in the volcanic region. The stress of initial dynamic triggering of the M ~(S)9.0 Tohoku earthquake was about 0.09?MPa, which is much higher than the threshold value of dynamic triggering stress. The earthquakes after the M ~(S)9.0 Tohoku earthquake are related to dynamic triggering stress, but the events before the earthquake cannot be linked to seismic events, but may be related to the background seismicity or from other kinds of local sources, such as anthropogenic sources (i.e., explosions). Using two teleseismic filtering, the small background earthquakes in the Datong volcanic region occur frequently, thus we postulate that previous catalog does not apply bandpass filter to pick out the weak earthquakes, and some of the observed weak events were not triggered by changes in the dynamic stress field.
机译:摘要2013年4月20日庐山7.0级地震发生后,我们在距震中约870-1,452公里的山西省数字地震台站上采用了高通和低通滤波技术,在高通滤波波形中一次检测到一些与表面波首次到达相对应的地震。地震在山西省火山区的游鱼(YUY),山子枣(SZZ),上黄庄(SHZ)和振川(ZCH)的站中尤为明显,但未列入山西地震中。观察报告。这些地震发生在最大振幅瑞利波通过后的4–50?min,表面波的周期主要在15至20?s之后。作用于四个台站的瑞利波引起的库仑应力约为0.001?MPa,略低于动态触发的阈值,因此,我们可以得出结论,大同火山区对库仑应力更加敏感。更改。为了验证类似现象是否普遍存在,我们使用相同的滤波方法观察了2011年庐山M〜(S)7.0级地震和东北M〜(S)9.0级地震之前和之后5?h的对比连续波形数据。结果表明,类似的现象发生在地震发生前,但地震发生后的地震活动率却明显增加。由于这些微弱的地震很小,因此很难从三个或更多的站点获得明确的相位到达时间来定位它们。另外,P波和S波(S–P)之间的传播时间差均小于4?s,这意味着该事件应该发生在火山区台站周围34?km处。东北M〜(S)9.0级地震的初始动态触发应力约为0.09?MPa,远高于动态触发应力的阈值。东北M〜(S)9.0级地震后的地震与动态触发应力有关,但地震前的事件不能与地震事件联系在一起,而可能与背景地震活动性或其他本地来源有关,例如人为来源(即爆炸)。使用两次远震滤波,大同火山区的小背景地震频繁发生,因此我们假定先前的目录没有使用带通滤波器来挑选弱地震,并且观察到的一些弱事件不是由动态变化触发的。应力场。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号