...
首页> 外文期刊>International Journal of Engineering Management >A Study on Evaluation and Optimization of Gel Flooding in Liaohe Oil Field
【24h】

A Study on Evaluation and Optimization of Gel Flooding in Liaohe Oil Field

机译:辽河油田胶凝驱评价与优化研究

获取原文
           

摘要

There are many challenges during water injection such as the early breakthrough of injecting water, increasing of water production, and the rapid decline of oil rate. These problems are often faced during water flooding application, and many oil field around the world are experiencing these kinds of problems. Liaohe oil field, is not spared of this problem related to the excessive production of water. Therefore, due to this circumstance, conformance treatment has been applied to solve this problem in that oil field. Gel treatment is one of the viable solution to mitigate sweep conformance problems, decrease the excessive production of water and improve oil recovery. Before, gel treatment in Liaohe oil field especially in Hai1 block, laboratory study under field conditions was carried out to determine the chemical parameters of the gel injection. Thus, we also brought a simulation approach in this research. Therefore, a brief study on gel flooding treatment has been presented and investigated in Hai 1 block of Liaohe oil field in this paper. Three well patterns such as five point, seven point and nine point, were developed for water flooding and gel flooding. Step by step for each scenario, based on the reservoir parameters and fluid properties of the actual oil field, the injection rate and the liquid production rate have been optimized including well pattern. The results of the simulation showed that seven spot is the best well pattern and it is suitable for the model established in this research. In addition, after two years of gel injection, the excessive production of water decreases from 98 to 84% and the ultimate oil recovery increases up to 34% for gel flooding compare to 28% obtained during water flooding.
机译:注水过程中存在许多挑战,例如注水的早期突破,产水量的增加以及油价的迅速下降。这些问题通常在注水应用中面临,并且世界各地的许多油田都在经历这类问题。辽河油田也没有幸免于与水产量过剩有关的问题。因此,由于这种情况,在该油田中已经采用一致性处理来解决该问题。凝胶处理是缓解扫掠一致性问题,减少水的过量产生并改善油采收率的可行解决方案之一。在辽河油田特别是海1区块进行凝胶处理之前,在野外条件下进行了实验室研究,以确定凝胶注入物的化学参数。因此,我们在本研究中也提出了一种仿真方法。因此,本文对辽河油田海一区块凝胶驱油技术进行了简要的研究。为注水和凝胶注水开发了三口井模式,如五点,七点和九点。针对每种情况,逐步根据储层参数和实际油田的流体特性,对包括井网在内的注入速率和产液率进行了优化。仿真结果表明,七个点是最好的井网,适合本研究建立的模型。此外,注胶两年后,过多的水产量从98%降至84%,凝胶注水的最终采油率提高至34%,而注水期间则为28%。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号