Roof Weakening of Hydraulic Fracturing for Control of Hanging Roof in the Face end of High Gassy Coal Longwall Mining: a Case Study

摘要

The occurence of hanging roof commonly arises in the face end of longwall coal mining under hard?roof conditions. The sudden break and subsequent caving of a hanging roof could result in the extrusion of?gas in the gob to the face, causing gas concentrations to rise sharply and to increase to over a safety-limited?value. A series of linear fracturing-holes of 32 mm diameter were drilled into the roof of the entries with?an anchor rig. According to the theory that the gob should be fully filled with the fragmentized falling?roof rock, the drilling depth is determined as being 3~5 times the mining height if the broken expansion?coefficient takes an empirical value. Considering the general extension range of cracks and the supporting?form of the entryway, the spacing distance between two drilling holes is determined as being 1~2 times?the crack’s range of extension. Using a mounting pipe, a high pressure resistant sealing device of a small?diameter-size was sent to the designated location for the high-pressure hydraulic fracturing of the roof?rock. The hydraulic fracturing created the main hydro-fracturing crack and airfoil branch cracks in the?interior of the roof-rock, transforming the roof structure and weakening the strength of the roof to form?a weak plane which accelerated roof caving, and eventually induced the full caving in of the roof in time?with the help of ground pressure. For holes deeper than 4 m, retreating hydraulic fracturing could ensure?the uniformity of crack extension. Tested and applied at s everal mines in Shengdong Mining District,?the highest ruptured water pressure was found to be 55 MPa, and the hanging roof at the face end was?reduced in length from 12 m to less than 1~2 m. This technology has eliminated the risk of the extrusion?of gas which has accumulated in the gob.