首页> 外文期刊>Combustion and Flame >Impact of branched structures on cycloalkane ignition in a motored engine: Detailed product and conformational analyses
【24h】

Impact of branched structures on cycloalkane ignition in a motored engine: Detailed product and conformational analyses

机译:支链结构对机动发动机中环烷烃点火的影响:详细的产品和构象分析

获取原文
获取原文并翻译 | 示例
           

摘要

The ignition process of ethylcyclohexane (ECH) and its two isomers, 1,3-dimethylcyclohexane (13DMCH) and 1,2-dimethylcyclohexane (12DMCH) was investigated in a modified CFR engine. The experiment was conducted with intake air temperature-of 155 degrees C, equivalence ratio of 0.5 and engine speed of 600 rpm. The engine compression ratio (CR) was gradually increased in a stepwise manner until autoignition occurred. It was found that ECH exhibited a significantly higher oxidation reactivity compared to its two isomers. The autoignition criterion was based on CO emissions and the apparent heat release rates. Ethylcyclohexane (ECH) indicated noticeable two stage ignition behavior, while less significant heat release occurred for the two isomers at comparable conditions. The mole fractions of unreacted fuel and stable intermediate species over a wide range of compression ratios were analyzed by GC-MS and GC-FID. Most of the species indicated constant rates of formation and the trends of relative yield to unreacted fuel are well in agreement with the oxidation reactivity in the low temperature regime. The major intermediate species are revealed as a group of conjugate olefins, which possess the same molecular structure as the original fuel compound except for the presence of a double carbon bond. Conjugate olefins were mostly formed through (1,4) H-shift isomerization during the low temperature oxidation of alkylcyclohexanes. Conformation analysis explains the reactivity differences in the three isomers as well as the fractions of intermediate species. The hydrogen availability located in alkyl substituents plays an important role in determining oxidation reactivity, requiring less activation energy for abstraction through the (1,5) H-shift isomerization. This reactivity difference contributes to building up the major intermediate species observed during oxidation of each test fuel. 12DMCH, whose ignition reactivity is the lowest, less favors beta-scission of C-C backbone of cyclic ring, thereby resulting in lower concentrations of small olefins and higher concentrations of conjugate olefins and large oxygenated species in the low temperature regime, prior to autoignition. (C) 2014 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
机译:在改进的CFR发动机中研究了乙基环己烷(ECH)及其两个异构体1,3-二甲基环己烷(13DMCH)和1,2-二甲基环己烷(12DMCH)的着火过程。该实验是在进气温度为155摄氏度,当量比为0.5和发动机转速为600 rpm的条件下进行的。发动机压缩比(CR)逐步增加,直到发生自燃为止。发现ECH与其两种异构体相比,表现出明显更高的氧化反应性。自燃标准基于一氧化碳排放量和视在放热率。乙基环己烷(ECH)表现出明显的两阶段着火行为,而在相当的条件下,这两种异构体的热释放较少。通过GC-MS和GC-FID分析了在宽压缩比范围内未反应的燃料和稳定的中间物种的摩尔分数。大多数种类表明形成速率恒定,未反应燃料的相对产率趋势与低温条件下的氧化反应性完全吻合。主要的中间物质以一组共轭烯烃的形式揭示,它们具有与原始燃料化合物相同的分子结构,但存在双碳键。共轭烯烃主要通过烷基环己烷的低温氧化过程中的(1,4)H-移异构化形成。构象分析解释了三种异构体的反应性差异以及中间物种的馏分。位于烷基取代基中的氢的可用性在确定氧化反应性方面起着重要作用,通过(1,5)H移异构化所需的活化能更少。这种反应性差异有助于在每种测试燃料的氧化过程中形成主要的中间物种。点火反应活性最低的12DMCH较不赞成环状C-C主链的β断裂,因此在自燃之前的低温条件下会导致较低浓度的小烯烃和较高浓度的共轭烯烃以及较大的氧化物种。 (C)2014年燃烧研究所。由Elsevier Inc.出版。保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号