首页> 外文期刊>Combustion and Flame >Flame resolved simulation of a turbulent premixed bluff-body burner experiment. Part II: A-priori and a-posteriori investigation of sub-grid scale wrinkling closures in the context of artificially thickened flame modeling
【24h】

Flame resolved simulation of a turbulent premixed bluff-body burner experiment. Part II: A-priori and a-posteriori investigation of sub-grid scale wrinkling closures in the context of artificially thickened flame modeling

机译:湍流预混合钝体燃烧器实验的火焰解析模拟。第二部分:在人工增厚火焰建模的背景下对亚网格规模的皱纹封闭进行先验和后验研究

获取原文
获取原文并翻译 | 示例
           

摘要

Dynamic sub-filter closures for artificially thickened flame (ATF) combustion models for large eddy simulation (LES) are investigated with consistent a-priori and a-posteriori analyses. The analyses are based on a flame resolved simulation (quasi DNS) and large eddy simulations of the bluff body burner experiment by Hochgreb and Barlow with premixed flamelet generated manifolds (PFGM). Both flame resolved simulation and LES are performed under the conditions of a single real flame experiment, using the same domain size, filter sizes, boundary conditions and numerics, all with an additional validation by comparison to experimental data. For the evaluation of the sub-filter wrinkling factor, the well-established model by Charlette et al. (2002) in the modified version by Wang et al. (2011) is used with a static and with a dynamic model parameter, a new dynamic power-law model is discussed additionally. In the a priori analysis, the probability density functions (PDFs) of the sub-grid scale (SGS) wrinkling factor are compared against the modeled ones based on the flame resolved simulation data. These a-priori modeled wrinkling factor PDFs are then compared against the a-posteriori ones from the LES results, where a similar shape is observed for all models. The static model tends to over-predict the wrinkling factor, a better agreement is found for the dynamic models for the medium and small filter width, where the new formulation improves the results for the latter. For the largest filter width, the wrinkling factor is under predicted by the dynamic models. This under-prediction is, however, compensated by larger gradients of the progress variable field so that the mean flame surface density conditioned on the progress variable is in closer agreement with the flame resolved simulation than the wrinkling factor PDFs are. Finally, radial profiles of the time-averaged temperature from the LES, flame resolved simulation and experiment are compared against each other. With the dynamic SGS wrinkling models, the LES results converge with grid refinement against the flame resolved simulation results. (C) 2017 The Combustion Institute. Published by Elsevier Inc. All rights reserved.
机译:使用一致的先验和后验分析研究了用于大涡模拟(LES)的人工增厚火焰(ATF)燃烧模型的动态子过滤器关闭。该分析基于Hochgreb和Barlow使用预混小火焰生成歧管(PFGM)进行的火焰分辨模拟(准DNS)和大涡流燃烧器实验的大涡模拟。火焰解析模拟和LES都是在单个真实火焰实验的条件下执行的,使用相同的域大小,过滤器大小,边界条件和数值,所有这些都通过与实验数据进行比较而得到额外的验证。为了评估子过滤器的起皱因子,Charlette等人建立了完善的模型。 (2002)在Wang等人的修改版本中。 (2011年)与静态和动态模型参数一起使用,另外讨论了新的动态幂律模型。在先验分析中,基于火焰分解的仿真数据,将子网格比例(SGS)起皱因子的概率密度函数(PDFs)与建模因子进行了比较。然后,将这些先验建模的起皱因子PDF与LES结果中的后验因子PDF进行比较,在所有模型中都观察到相似的形状。静态模型往往会过高地预测皱纹因子,对于中等和较小滤嘴宽度的动态模型可以找到更好的一致性,其中新的公式改进了后者的结果。对于最大的过滤器宽度,动态模型无法预测起皱因子。但是,此不足预测由进度变量场的较大梯度所补偿,因此,与起皱因子PDF相比,以进度变量为条件的平均火焰表面密度与火焰解析模拟更接近。最后,将来自LES的时间平均温度的径向分布,火焰分辨模拟和实验进行了相互比较。利用动态SGS起皱模型,LES结果与网格细化相对于火焰解析模拟结果收敛。 (C)2017燃烧研究所。由Elsevier Inc.出版。保留所有权利。

著录项

相似文献

  • 外文文献
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号