首页> 外文期刊>Chemosphere >Diffusion coefficients of polar organic compounds in agarose hydrogel and water and their use for estimating uptake in passive samplers
【24h】

Diffusion coefficients of polar organic compounds in agarose hydrogel and water and their use for estimating uptake in passive samplers

机译:琼脂糖水凝胶和水中极性有机化合物的扩散系数及其用于估计被动采样器摄取的用途

获取原文
获取原文并翻译 | 示例
           

摘要

Diffusion coefficient (D) is an important parameter for prediction of micropollutant uptake kinetics in passive samplers. Passive samplers are nowadays commonly used for monitoring trace organic pollutants in different environmental matrices. Samplers utilising a hydrogel layer to control compound diffusion are gaining popularity. In this work we investigated diffusion of several perfluoroalkyl substances, currently used pesticides, pharmaceuticals and personal care products in 1.5% agarose hydrogel by measuring diffusion coefficients using two methods: a diffusion cell and a sheet stacking technique. Further, diffusion coefficients in water were measured using Taylor dispersion method. The sheet stacking method was used to measure D at 5, 12, 24, and 33 degrees C in order to investigate temperature effect on diffusion. Median D values ranged from 2.0 to 8.6 x 10(-6) cm(2) s(-1) and from 2.1 to 8.5 x 10(-6) cm(2) s(-1) for the diffusion cell and sheet stack methods respectively. For most compounds, the variability between replicates was higher than the difference between values obtained by the two methods. Rising temperature from 10 to 20 degrees C increases the diffusion rate by the factor of 1.41 +/- 0.10 in average. In water, average D values ranged from 3.03 to 10.0 x 10(-6) cm(2) s(-1) and were comparable to values in hydrogel, but some compounds including perfluoroalkyl substances with a long aliphatic chain could not be evaluated properly due to sorptive interactions with capillary walls in the Taylor dispersion method. Sampling rates estimated using the measured D values were systematically higher than values estimated from laboratory sampler calibration in our previously published study, by the factor of 2.2 +/- 1.0 in average. (C) 2020 Elsevier Ltd. All rights reserved.
机译:扩散系数(d)是用于预测被动采样器中微核性摄取动力学的重要参数。如今被动采样器通常用于监测不同环境基质中的痕量有机污染物。利用水凝胶层对化合物扩散的采样器是普及的。在这项工作中,我们通过使用两种方法测量扩散系数来调查几种全氟烷基物质,目前使用的杀虫剂,药物和个人护理产品的扩散,目前使用了1.5%琼脂糖水凝胶:扩散单元和纸张堆叠技术。此外,使用泰勒分散方法测量水中的扩散系数。纸张堆叠方法用于测量5,12,24和33摄氏度的D,以研究温度对扩散的影响。中位数D值范围为2.0至8.6×10(-6)cm(2)厘米(-1)和2.1至8.5 x 10(-6)cm(2)s(2)s(2)s(2)s(2)s(2)s(-1),用于扩散电池和片材堆叠方法分别。对于大多数化合物,复制之间的可变性高于通过两种方法获得的值之间的差异。从10到20摄氏度的上升温度会使扩散速度平​​均增加1.41 +/- 0.10。在水中,平均d值范围为3.03至10.0×10(-6)cm(2)s(2)s(2)s(2)s(-1),并且与水凝胶的值相当,但是包含具有长脂族链的全氟烷基物质的一些化合物无法正确评估由于泰勒分散方法中与毛细血管壁的相互作用。使用测量的D值估计的采样率系统地高于我们之前发表的研究中的实验室采样器校准估计的值,平均值为2.2 +/- 1.0。 (c)2020 elestvier有限公司保留所有权利。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号