Improving Variable-Speed Pumping Control to Maximize Savings

摘要

According to some estimates, pumps account for between 10% and 20% of world electricity consumption (EERE 2001; Grundfos2011). Unfortunately, about two-thirds of all pumps use up to 60% too much energy (Grundfos 2011), primarily because of inefficient flow control. Varying pump speed using a variable-frequency drive (VFD) on the pump motor is one of the most efficient methods of flow control. As a consequence, about one-fifth of all U.S. utilities incentivize VFDs (NCSU 2014), and many of these drives control pumping systems. However, field studies and research show that few variable-flow systems are optimally controlled, and the fraction of actual to ideal savings is frequently as low as 40% (Kissock 2012; Ma etal. 2015; L. Song, Assistant Professor, Department of Mechanical Engineering, University of Oklahoma, pers. comm., July, 2013). Utility incentive programs that rely on ideal energy saving calculations could overestimate savings by 30% (Maxwell 2005). Previous work has shown the importance of changing motor efficiency, VFD efficiency, and pump efficiency on savings (Bernier and Bourret 1999;Maxwell 2005). Thiswork considers the difference between actual and ideal savings caused by excess bypass flow, positions and setpoints of control sensors, and control algorithms. This paper examines the influence of these factors on energy savings using simulations, experimental data, and field measurements. Ingeneral, energy savings are increasedwhen bypass is minimized or eliminated, pressure sensors for control are located near the most remote end use, and the pressure control setpoint is minimized.