首页> 外文期刊>Applied Surface Science >Thermal annealing dependence of some optical properties of plasma-modified porous silicon
【24h】

Thermal annealing dependence of some optical properties of plasma-modified porous silicon

机译:等离子体改性多孔硅某些光学性质的热退火依赖性

获取原文
获取原文并翻译 | 示例
           

摘要

The photoluminescence and reflectance of porous silicon (PS) with and without hydrocarbon (CH_X) deposition fabricated by plasma enhanced chemical vapour deposition (PECVD) technique have been investigated. The PS samples were then, annealed at temperatures between 200 and 800 ℃ The influence of thermal annealing on optical properties of the hydrocarbon layer/porous silicon/silicon structure (CH_x/PS/Si) was studied by means of photoluminescence (PL) measurements, reflectivity and ellipsom-etry spectroscopy. The composition of the PS surface was monitored by transmission Fourier transform infrared (FTIR) spectroscopy. Photoluminescence and reflectance measurements were carried out before and after annealing on the carbonized samples for wavelengths between 250 and 1200 nm. A reduction of the reflectance in the ultraviolet region of the spectrum was observed for the hydrocarbon deposited polished silicon samples but an opposite behaviour was found in the case of the CH_x/PS ones. From the comparison of the photoluminescence and reflectance spectra, it was found that most of the contribution of the PL in the porous silicon came from its upper interface. The PL and reflectance spectra were found to be opposite to one another. Increasing the annealing temperature reduced the PL intensity and an increase in the ultraviolet reflectance was observed. These observations, consistent with a surface dominated emission process, suggest that the surface state of the PS is the principal determinant of the PL spectrum and the PL efficiency.
机译:研究了通过等离子增强化学气相沉积(PECVD)技术制造的具有和不具有碳氢化合物(CH_X)沉积的多孔硅(PS)的光致发光和反射率。然后将PS样品在200到800℃的温度下进行退火。通过光致发光(PL)测量研究了热退火对烃层/多孔硅/硅结构(CH_x / PS / Si)光学性能的影响,反射率和椭球光谱。通过透射傅立叶变换红外(FTIR)光谱监测PS表面的组成。在碳化样品上退火之前和之后,对波长在250至1200 nm之间的光致发光和反射率进行测量。对于烃沉积的抛光硅样品,观察到光谱的紫外区域的反射率降低,但是在CH_x / PS样品的情况下,发现相反的行为。通过光致发光和反射光谱的比较,发现多孔硅中PL的大部分贡献来自其上界面。发现PL和反射光谱彼此相反。升高退火温度降低了PL强度,并且观察到了紫外线反射率的增加。这些观察结果与表面主导的发射过程一致,表明PS的表面状态是PL光谱和PL效率的主要决定因素。

著录项

  • 来源
    《Applied Surface Science》 |2010年第3期|p.1105-1111|共7页
  • 作者单位

    Unite de Developpement de la Technologie du Sili-cium, Photovoltaic Cell Laboratory, 2 Boulevard Frantz Fanon, B.P. 140, Alger-7Merveilles, Algiers 16200, Algeria;

    Unite de Developpement de la Technologie du Silicium, 2 Boulevard Frantz Fanon, B.P. 140, Alger-7 Merveilles, Algiers 16200, Algeria;

    Centre de Recherche Nucleate d'Alger, CRNA, 2 Boulevard Frantz Fanon, B.P. 140, Alger-7 Merveilles, Algiers 16200, Algeria;

    Unite de Developpement de la Technologie du Silicium, 2 Boulevard Frantz Fanon, B.P. 140, Alger-7 Merveilles, Algiers 16200, Algeria;

    Unite de Developpement de la Technologie du Silicium, 2 Boulevard Frantz Fanon, B.P. 140, Alger-7 Merveilles, Algiers 16200, Algeria;

  • 收录信息
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

    porous silicon; hydrocarbon layer; photoluminescence; reflectance;

    机译:多孔硅烃层光致发光反射率;

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号