首页> 外文期刊>Applied Energy >Thermodynamic and economic analysis of a supercritical and an ultracritical oxy-type power plant without and with waste heat recovery
【24h】

Thermodynamic and economic analysis of a supercritical and an ultracritical oxy-type power plant without and with waste heat recovery

机译:无废热回收和超废热回收的超临界和超临界氧型电厂的热力学和经济分析

获取原文
获取原文并翻译 | 示例
           

摘要

Thermodynamic and economic analysis of two variants (W1 and W2) of an oxy-type power plant (with or without waste heat recovery) are presented in this paper. This plant consists of: a hard-coal-fired pulverized-fuel boiler, a steam turbine unit, a CO2 capture and compression unit and an air separation unit (with a four-end-type high-temperature membrane). A steam turboset gross electric power of 600 MW was assumed. Variants of the oxy-type plant have different live steam parameters (W1-650 degrees C/30 MPa; W2-700 degrees C/35 MPa), reheated steam parameters (W1-670 degrees C/6 MPa; W2-720 degrees C/6.5 MPa) and structures of the steam turbine unit. Two methods of utilization of waste heat were analyzed: replacement of regenerative feed water heaters and implementation of an additional ORC unit. The characteristics of the thermodynamic and economic analysis of the analyzed plant were determined as a function of the air compressor pressure ratio (beta) and oxygen recovery rate (R). The values of these quantities were determined to ensure maximal net efficiency of the plant and the best value of the economic indicator. The results show that utilization of waste heat is essential for efficiency and economic indicator values of the oxy-type plant and optimal values of beta and R. The net efficiency of the oxy-type plant can be 4.06 p.p. lower than the analogous efficiency of the reference plant (consisting of a classic pulverized-fuel boiler and steam turbine unit). This decrease of the efficiency is one of the lowest among the CO2 capture technologies. (C) 2016 Published by Elsevier Ltd.
机译:本文介绍了氧型发电厂(有或没有废热回收)的两种变体(W1和W2)的热力学和经济分析。该工厂包括:硬煤粉燃料锅炉,蒸汽轮机单元,CO2捕集和压缩单元以及空气分离单元(带有四端型高温膜)。假设蒸汽涡轮机组的总电功率为600 MW。氧型设备的变体具有不同的新鲜蒸汽参数(W1-650摄氏度/ 30 MPa; W2-700摄氏度/ 35 MPa),再热蒸汽参数(W1-670摄氏度/ 6 MPa; W2-720摄氏度) /6.5 MPa)和蒸汽轮机单元的结构。分析了两种利用废热的方法:更换再生式给水加热器和实施一个额外的ORC单元。确定了所分析工厂的热力学和经济分析特征,该特征取决于空气压缩机压力比(β)和氧气回收率(R)。确定这些数量的值是为了确保工厂的最大净效率和经济指标的最佳值。结果表明,利用余热对于氧型装置的效率和经济指标值以及最佳的β和R值至关重要。氧型装置的净效率可以为4.06p.p。低于参考工厂的类似效率(由传统的粉燃料锅炉和蒸汽轮机组成)。效率下降是二氧化碳捕集技术中最低的之一。 (C)2016由Elsevier Ltd.出版

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号