Investigation of Wear Behavior of Precipitation-Strengthened Nickel-Copper Based K-500 Alloy Produced by Powder Metallurgy

摘要

The present study investigates the effects of the ageing parameters of the precipitation-strengthened nickel-copper based K-500 alloy produced by powder metallurgy on the wear behavior of the alloy. After the cold pressing the prepared alloy powders under 600 MPa pressure, the samples were sintered under vacuum (10(-6) mbar) at 1150 degrees C for 2 h and then cooled in the furnace. Produced K-500 alloy samples were taken into solution at 980 degrees C for 1 h and quenched. Ageing process was carried out at 480 degrees C for four different time periods (6, 8, 10, and 12 h). Aged samples were examined transmission electron microscope (TEM + EDS), X-ray diffraction (XRD), hardness and density measurements. The wear tests were carried out at 1 ms(-1) constant sliding speed, under 40 N load and for five different sliding distances (400-2000 m). The results showed that there is gamma' Ni-3 (Al, Ti) inter-metallic phase coexisting with Al-0.9 Ni-4.22, AlNi(3)and NiO phases. According to the hardness measurements, the highest hardness values were obtained with samples aged for 8 h. In wear tests with 2000 m sliding distance, the lowest weight loss was observed for the samples aged for 8 h.