首页> 外文学位 >Development of an Ammonia Reduction After-Treatment Systems for Stoichiometric Natural Gas Engines
【24h】

Development of an Ammonia Reduction After-Treatment Systems for Stoichiometric Natural Gas Engines

机译:化学计量天然气发动机减氨后处理系统的开发

获取原文
获取原文并翻译 | 示例

摘要

Three-way catalyst (TWC) equipped stoichiometric natural gas vehicles have proven to be an effective alternative fuel strategy that shows significant low NOx emissions characteristics. However, recent studies have shown the TWC activity to contribute to elevated levels of tailpipe ammonia (NH 3) emissions. Although a non-regulated pollutant, ammonia is a potent pre-cursor to ambient secondary PM formation. Ammonia is an inevitable byproduct of fuel rich operation that results in lowest NOx slip through the TWC after-treatment system.;The main objective of the study is to develop a passive Ammonia Reduction Catalyst (passive-ARC) based NH3 reduction strategy that results in an overall reduction of ammonia as well as NOx emissions. The study investigated the characteristics of Fe-based and Cu-based zeolites SCR catalysts in storage and desorption of ammonia at high exhaust temperature conditions, that are typical of stoichiometric natural gas engines. Continuous measurements of NOx and NH3 before and after the SCR systems were conducted using a Fourier Transform Infrared Spectrometry (FTIR) gas analyzer. Results of the investigation showed that both, the Fe- and Cu zeolite SCRs adsorbed above 90% of TWC generated NH3 emissions below 350--375 °C SCR temperatures. Desorption or slipping of NH3 was observed at exhaust gas temperatures exceeding 400 °C. In terms of NOx conversions, Fe-zeolite showed efficiency between 50--80% above temperatures of 300--350 °C while Cu-zeolite performed well at lower SCR temperature from 250 °C and above with a conversion efficiency of greater than 50%.;In order to efficiently reduce both NOx and NH3 simultaneously over longer durations it was found that an engine-based air fuel ratio operation strategy for the passive-ARC system must be developed. To this extent, the study extended its objectives to develop an engine-based control strategy that results in stoichiometric ammonia production operation followed by brief lean operation to regenerate the saturated ammonia reduction catalyst using high NOx slip through TWC. The study presents comprehensive results of ammonia storage characteristics of SCRs pertaining to stoichiometric natural gas engine exhaust as well as an advanced engine control strategy approach to simultaneously reduce both NOx and NH3 using an alternating air -fuel ratio approach.
机译:事实证明,配备三元催化器(TWC)的化学计量天然气汽车是一种有效的替代燃料策略,具有明显的低NOx排放特征。但是,最近的研究表明,TWC活性有助于提高排气管氨(NH 3)排放水平。氨虽然是不受管制的污染物,但却是环境中次级PM形成的有效前体。氨是富油运行的不可避免的副产物,其通过TWC后处理系统导致最低的NOx泄漏。该研究的主要目的是开发基于被动氨还原催化剂(passive-ARC)的NH3还原策略,从而实现总体上减少了氨以及NOx的排放。这项研究研究了Fe基和Cu基沸石SCR催化剂在高排气温度条件下氨的存储和解吸中的特性,这是化学计量天然气发动机的典型特征。使用傅立叶变换红外光谱(FTIR)气体分析仪对SCR系统之前和之后的NOx和NH3进行连续测量。研究结果表明,吸附在TWC的90%以上的Fe和Cu沸石SCR都在SCR温度低于350--375°C时产生NH3排放。在排气温度超过400°C时观察到NH3的解吸或泄漏。就NOx转化而言,Fe沸石在300--350°C的温度下显示出50--80%的效率,而Cu沸石在SCR温度从250°C以上的情况下表现良好,转化率大于50为了在更长的时间内同时有效地还原NOx和NH3,人们发现必须为被动式ARC系统开发基于发动机的空燃比运行策略。在这个程度上,这项研究扩展了其目标,即开发一种基于发动机的控制策略,该策略导致化学计量的氨生产操作,然后进行短暂的稀薄操作,以使用通过TWC的高NOx泄漏来再生饱和氨还原催化剂。该研究提出了与化学计量天然气发动机废气有关的SCR的氨存储特性的综合结果,以及一种先进的发动机控制策略方法,该方法通过使用交替的空燃比方法同时还原NOx和NH3。

著录项

  • 作者

    Pradhan, Saroj.;

  • 作者单位

    West Virginia University.;

  • 授予单位 West Virginia University.;
  • 学科 Mechanical engineering.;Engineering.
  • 学位 Ph.D.
  • 年度 2017
  • 页码 138 p.
  • 总页数 138
  • 原文格式 PDF
  • 正文语种 eng
  • 中图分类
  • 关键词

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号