CHANGE YOUR MAINTENANCE PHILOSOPHY WHEN YOU CONVERT A BASE LOADED UNIT TO CYCLING OPERATION

摘要

With the fuel prices going up and many states mandating use of more renewable energy, a number of utilities are forced to convert some of their base loaded units to cycling operation. This change in operation requires a departure from the standard maintenance practices established for a given unit. This includes changes to Preventative Maintenance (PM), Predictive Maintenance (PdM), Planning and Scheduling and Key Performance Indicators (KPIs). When a unit is cycled - either minimum load to maximum load or two shift operation - it goes through stress cycles and its expected life decreases relative to the severity of cycling. When a decision is made to cycle a base loaded unit, the impact of the cycling has to be analyzed and the PM and PdM procedures need to be modified in order to maintain the expected life of the components. Cycling affects different components to different degrees and appropriate inspection and maintenance schedules need to be developed. The Key Performance Indicators (KPIs) have to be modified to monitor the effectiveness of the inspections and maintenance performed on the equipment. For example, Maintenance Basis Violation (MBV) is an important KPI for a cycling unit. Similarly, more attention has to be paid to the Planning and Scheduling activities as there are many uncertainties in the availability of the unit for preventative maintenance. The paradigm of performing PMs on a time basis should be changed to a throughput or hours of operation basis. This paper reviews the impact and severity of different cycling modes on a unit, vulnerability of common components adapting to the new mode, and discusses - in general terms - the required changes which need to be made in the inspection and maintenance practices. Also the paper reviews various KPIs that can be put in place for monitoring the impact of these procedures.