首页> 外文会议>IMECE2009;ASME international mechanical engineering congress and exposition >REDUCTION OF NITRIC OXIDE EMISSION FROM A SI ENGINE BY WATER INJECTION AT THE INTAKE RUNNER
【24h】

REDUCTION OF NITRIC OXIDE EMISSION FROM A SI ENGINE BY WATER INJECTION AT THE INTAKE RUNNER

机译:通过进水口注水减少SI发动机的一氧化氮排放

获取原文

摘要

The effects of pulsed water injection at the intake port of a modem port fuel injection gasoline engine were investigated. A port water injection system was developed and the water injector was installed on the intake runner of the single cylinder motorcycle engine at a location upstream of the fuel injector. The results show that with a water-gasoline injection ratio of 1, more than 80 % of NOx emission can be removed. The trade-off was a 25 % reduction in torque output at 4000 rpm and 20 % throttle opening; however, the decrease on torque can be controlled to be within 5 % by reducing water-gasoline mass ratios to less than 0.6. We also performed NOx emission modeling using one-dimensional gas dynamics code with extended Zeldovich mechanism, and consistent results were found between numerical prediction and experimental measurements. The port water injection approach appears to be an effective means for reducing NOx emission from a gasoline engine at low speed and high load conditions without largely sacrificing the performances on torque output and unburned hydrocarbon emissions.
机译:研究了在现代端口燃油喷射汽油发动机的进气口处脉冲水喷射的影响。开发了端口注水系统,并将注水器安装在单缸摩托车发动机的进气流道上,位于喷油器上游。结果表明,在水汽油喷射比为1的情况下,可以消除80%以上的NOx排放。折衷方案是在4000 rpm和20%的节气门开度下将扭矩输出降低25%。但是,通过将水-汽油的质量比降低至小于0.6,可以将转矩的降低控制在5%以内。我们还使用具有扩展Zeldovich机理的一维气体动力学代码进行了NOx排放建模,并且在数值预测和实验测量之间发现了一致的结果。港口注水方法似乎是减少汽油发动机在低速和高负荷条件下排放NOx的有效手段,而又不会大幅降低扭矩输出和未燃烧碳氢化合物的排放性能。

著录项

相似文献

  • 外文文献
  • 中文文献
  • 专利
获取原文

客服邮箱:kefu@zhangqiaokeyan.com

京公网安备:11010802029741号 ICP备案号:京ICP备15016152号-6 六维联合信息科技 (北京) 有限公司©版权所有
  • 客服微信

  • 服务号