The TurkStream pipeline project is designed to transport approximately 32 billion cubic meters of natural gas annually from Russia to Turkey under the Black Sea, with more than 85% of the deep-water route being deeper than 2000 m. The offshore section is intended to consist of two parallel lines, each approximately 900 km long. The preliminary stages of the front end engineering design (pre-FEED) phase was managed by INTECSEA. To support the analyses and design of the deepest portions, a full scale collapse test program was performed by C-FER Technologies (C-FER). This collapse test program, which included 62 full-scale collapse and pressure+bend tests, 54 medium-scale ring collapse tests, and hundreds of small-scale tests, was primarily aimed at measuring, quantifying and documenting the increase in pipe strength and collapse resistance resulting from the thermal induction heat treatment effect (thermal ageing) that arises during the pipe coating process. Two grades of 32-inch (813 mm) outside diameter (OD) line-pipe, SAWL450 and SAWL485 with wall thicknesses of 39.0 mm or 37.4 mm, respectively, were supplied from various mills for testing. The collapse test program objectives were as follows: 1. Determine the collapse resistance of line pipes originating from various pipe mills; 2. Determine the pressure+bend performance of line pipes originating from various pipe mills; 3. Measure the effect of thermal ageing on material and collapse testing results, including the impact of multiple thermal cycles; and 4. Evaluate the results of medium-scale ring collapse tests as compared to full-scale tests. This paper presents selected results of this work, along with some comparisons to predictive equations.
展开▼
