Performance testing of unbound materials within the pavement foundation

摘要

Pavement design requires knowledge of the performance of the foundation layers. The specific condition at a given site can be considered in the design; such as the use of locally available material, recycled or secondary aggregate in the pavement foundation, provided the specified end-product performance requirements are achieved. Performance testing is required in order to ensure that the design assumptions for the material properties are met during construction. Both the capping and sub-base layers need to attain adequate strength and stiffness. Therefore there is a need to undertake complimentary compliance testing that would include target values based on the behaviour of the materials. This paper describes the research into the development of performance testing for foundation layers based on case studies performed by Scott Wilson Pavement Engineering (SWPE). The performance testing was carried out by Falling Weight Deflectometer (FWD), German Dynamic Plate (GDP) and Prima 100. The results using these test methods were compared and correlated. The results indicated that the relationships between FWD, GDP and Prima were material type and thickness dependent. The Prima usually gave broadly similar results to the FWD, but was significantly more variable from point to point. The GDP almost always gave a lower stiffness than the other devices, but to varying degrees.